Abstract:Nowadays, the operating principle of most of the experimental electromagnetic glucose sensors is based on the effect of an anomalous dispersion caused by a direct contact between an object under test and a two-dimensional metasurface. Due to the repeated uses, the metasurface will be subjected to a chemical attack over time. To avoid this problem, this work proposes a novel glucose sensor that is equipped with an interfacial dielectric layer of 0.254 mm thickness to separate the object under test and the metasurface. The results of our analysis suggest that, if the interfacial dielectric layer is sufficiently thin, there will be no shortage of sensitivity in the proposed sensor. Consistent with our theoretical prediction, the proposed sensor was found to resonate at 9–10 GHz, with its resonant frequency responding to the glucose concentration in a dose dependent manner. The correlation the resonant frequency shift and the glucose concentration was found to be highly linear over the clinical diabetic range with a sensitivity of 4 MHz/(mg dL −1 ). However, we could not obtain the same or similar sensitivity when the interfacial layer was substituted with a similar dielectric layer of 1 mm thick. Overall, the presence of the interfacial dielectric layer has not negatively impaired the sensing sensitivity of the glucose sensor if and only if its thickness was sufficiently small. This implication of this work can be advantageously used to tailor the future invivo glucose methodology or other health-care electronic devices.

Sensitivity Optimization of Antenna for Non-Invasive Blood Glucose Monitoring

Design of microstrip sensor for non invasive blood glucose monitoring

A wireless acoustic wave sensor modified with biocompatible polymer for glucose monitoring

A Wireless-Electrodeless Quartz Crystal Microbalance Method for Non-Enzymatic Glucose Monitoring

A Compact Wideband Vivaldi Antenna for Non-Invasive Glucose Monitoring

Ultra-Wideband Circular Polarized Implantable Patch Antenna for Implantable Blood Glucose Detection System Applications

Sensitivity evaluation of miniature microstrip line‐based sensors using multiple sensing parameters for non‐invasive blood glucose monitoring

A Wideband Circular Polarization Implantable Antenna for Health Monitor Microsystem

Design of Wideband and Flexible Implantable Antenna for Wireless Medical Application

Implantable small ultra-wideband circularly polarized antenna design for continuous blood pressure monitoring

A novel trident shaped microstrip antenna sensor for glucose detection in human blood

Highly Sensitive Closed Loop Enclosed Split Ring Biosensor With High Field Confinement for Aqueous and Blood-Glucose Measurements

Miniaturized Multiband Planar Sensor Based on Transmission Line Loaded With Pairs of Improved Resonators for Glucose-Aqueous Solution Sensing Applications

A miniaturized flexible implantable antenna with metamaterial resonators for biomedical applications

Frequency selective metasurface based radio frequency glucose sensor with a periodic array of meta cells

Sensitivity enhancement of surface plasmon resonance imaging sensor with structural parameter optimization based on polarization contrast modulation

Design of Circularly Polarized Implantable Antenna for Wireless Intracranial Pressure Monitoring System

Miniature implantable antennas for biomedical telemetry: from simulation to realization

A miniature and reusable radiofrequency biosensor combining microfluidic and integrated passive technology for glucose detection

Triple-Poles Complementary Split Ring Resonator for Sensing Diabetics Glucose Levels at cm-Band

Highly sensitive blood glucose monitoring sensor with adjustable resonant frequency based on MP-CSRR