Abstract:Abstract. Atmospheric aerosols are a significant public health hazard and have substantial impacts on the climate. Secondary organic aerosols (SOAs) have been shown to phase separate into a highly viscous organic outer layer surrounding an aqueous core. This phase separation can decrease the partitioning of semi-volatile and low-volatile species to the organic phase and alter the extent of acid-catalyzed reactions in the aqueous core. A new algorithm that can determine SOA phase separation based on their glass transition temperature (Tg), oxygen to carbon (O:C) ratio and organic mass to sulfate ratio, and meteorological conditions was implemented into the Community Multiscale Air Quality Modeling (CMAQ) system version 5.2.1 and was used to simulate the conditions in the continental United States for the summer of 2013. SOA formed at the ground/surface level was predicted to be phase separated with core–shell morphology, i.e., aqueous inorganic core surrounded by organic coating 65.4 % of the time during the 2013 Southern Oxidant and Aerosol Study (SOAS) on average in the isoprene-rich southeastern United States. Our estimate is in proximity to the previously reported ∼70 % in literature. The phase states of organic coatings switched between semi-solid and liquid states, depending on the environmental conditions. The semi-solid shell occurring with lower aerosol liquid water content (western United States and at higher altitudes) has a viscosity that was predicted to be 102–1012 Pa s, which resulted in organic mass being decreased due to diffusion limitation. Organic aerosol was primarily liquid where aerosol liquid water was dominant (eastern United States and at the surface), with a viscosity <102 Pa s. Phase separation while in a liquid phase state, i.e., liquid–liquid phase separation (LLPS), also reduces reactive uptake rates relative to homogeneous internally mixed liquid morphology but was lower than aerosols with a thick viscous organic shell. The sensitivity cases performed with different phase-separation parameterization and dissolution rate of isoprene epoxydiol (IEPOX) into the particle phase in CMAQ can have varying impact on fine particulate matter (PM2.5) organic mass, in terms of bias and error compared to field data collected during the 2013 SOAS. This highlights the need to better constrain the parameters that govern phase state and morphology of SOA, as well as expand mechanistic representation of multiphase chemistry for non-IEPOX SOA formation in models aided by novel experimental insights.

Supplementary Material to &quot;not All Types of Secondary Organic Aerosol Mix: Two Phases Observed when Mixing Different Secondary Organic Aerosol Types&quot;

Influence of Acidity on Liquid–liquid Phase Transitions of Mixed Secondary Organic Aerosol (SOA) Proxy–inorganic Aerosol Droplets

Markedly Different Impacts of Primary Emissions and Secondary Aerosol Formation on Aerosol Mixing States Revealed by Simultaneous Measurements of CCNC, H(/V)TDMA, and SP2

Characterization of Crucial Fragments During the Nucleation and Growth of Secondary Organic Aerosol from the High-No Photo-Oxidation of Α-Pinene

Insights into Secondary Organic Aerosol Formation Mechanisms from Measured Gas/Particle Partitioning of Specific Organic Tracer Compounds

Direct Observation for Relative-Humidity-dependent Mixing States of Submicron Particles Containing Organic Surfactants and Inorganic Salts

Phase State of Secondary Organic Aerosol in Chamber Photo-Oxidation of Mixed Precursors

Mixing States of Aerosol Particles in Urban Haze

Chemical Composition and Optical Properties of Secondary Organic Aerosol from Photooxidation of Volatile Organic Compound Mixtures

Synergetic formation of secondary inorganic and organic aerosol: Influence of SO&lt;sub&gt;2&lt;/sub&gt; and/or NH&lt;sub&gt;3&lt;/sub&gt; in the heterogeneous process

On Surface Order and Disorder of Α-Pinene-derived Secondary Organic Material.

Synergetic Formation of Secondary Inorganic and Organic Aerosol : Effect of SO 2 and NH 3 on Particle Formation and Growth

Effect of Particle Phase Oligomer Formation on Aerosol Growth

N2O5 Heterogeneous Uptake on Secondary Organic Aerosol: the Effect of Organic Coating Thickness, Relative Humidity and Phase State

Predicting secondary organic aerosol phase state and viscosity and its effect on multiphase chemistry in a regional-scale air quality model

Particle size dependence of biogenic secondary organic aerosol molecular composition

Impact of phase state and non-ideal mixing on equilibration timescales of secondary organic aerosol partitioning

Molecular Understanding of the Enhancement in Organic Aerosol Mass at High Relative Humidity

Glass Transition Temperatures of Organic Mixtures from Isoprene Epoxydiol-Derived Secondary Organic Aerosol

Similarities in STXM-NEXAFS Spectra of Atmospheric Particles and Secondary Organic Aerosol Generated from Glyoxal, Α-Pinene, Isoprene, 1,2,4-Trimethylbenzene, and D-Limonene

Supplementary Material to &amp;quot;not All Types of Secondary Organic Aerosol Mix: Two Phases Observed when Mixing Different Secondary Organic Aerosol Types&amp;quot;