Abstract:Thermal shrinkage has for long been a critical issue in nonwoven industrial applications. A dimensionally stable nonwoven web with excellent mechanical property was achieved by heat treatment with tension [taut annealed (TA)] instead of annealing under free state [free annealed (FA)], while the original high porosity was not affected. To better understand the fundamental structure-property relationship, these two different heat treatments' effects on the thermal behaviors, morphology, and phase structures of poly(phenylene sulfide) (PPS) nonwovens were elucidated via a combination of different experimental techniques such as temperature-modulated differential scanning calorimetry (DSC), two-dimensional wide-angle X-ray diffraction, two-dimensional small-angle X-ray scattering, and polarized Raman spectroscopy. It is evidenced that no obvious online stress-induced crystallization occurs during the melt-blowing process, making virgin PPS fibers mostly in the amorphous state. However, experimental results confirm that a certain amount of mesophase or constrained amorphous exists in the virgin PPS fibers without any presence of crystallites. After annealing, the DSC melting curves of both TA and FA PPS nonwovens exhibit endothermic annealing peaks, the origin of which is interpreted as the relaxation and devitrification of the rigid amorphous phase. However, the annealing peak position of the FA sample is always higher than that of the TA sample, which is reported for the first time. As compared with the FA sample annealed at the same temperature, TA PPS nonwovens reveal lower crystallinity and slightly larger lamellar long period (L-p) but a higher level of macroscopic fiber alignment and molecular chain orientation. These morphology and microstructure differences provide a good explanation for the superior mechanical property of TA PPS nonwovens with higher elastic modulus and tensile strength. The results are helpful in deepening the understanding of essential physical pictures of PPS nonwovens and promoting the development of the high-temperature nonwoven industry.

Effect of Special Heat Treatments on Silk Fibroin Structure and Properties

Influence of Irradiation Sterilization on Properties of Silk Fibroin Materials

Properties of Floss Silk with High Elasticity and Warmth Retention

Study on Silk Fibroin Coated PET Fabric

Effects of Different Structure Silk Fibroin on Crystallization of Hydroxyapatite

Effect of Lye Disposal and Draw on Performance of Floss Silk

Study on Emulsification of Silk Fibroin Solution

Relations Between Silk Surface Structure and the Dyeing Performance of the Reactive Dyes

Thermally induced increase in energy transport capacity of silkworm silks.

Effect of Different Additives in Diets on Secondary Structure, Thermal and Mechanical Properties of Silkworm Silk.

The Effect of Water on the Conformation Transition of Bombyx Mori Silk Fibroin

IMPROVING THE MECHANICAL PROPERTIES OF SILK FIBER/FIBROIN COMPOSITES BY INTERFACIAL MODIFICATION

Temperature‐Induced Effects on Wet‐Spun Artificial Spider Silk Fibers

Heat-setting Effect on the Morphology and Phase Structures of PPS Nonwovens

Effects of Thermal Treatment on the Mechanical Properties of Bamboo Fiber Bundles

Surface modification and functionalization of silk fibroin fibers/fabric toward high performance applications

Fabrication of Silk Fibroin Film with Properties of Thermal Insulation and Temperature Monitoring

Effect of post-treatment methods and nanoparticles on the conformation of silk fibroin and their impact on electrical properties

The Preparation of High Performance Silk Fiber/fibroin Composite

Investigation On The Structure And Mechanical Properties Of Highly Tunable Elastomeric Silk Fibroin Hydrogels Cross-Linked By Gamma-Ray Radiation

Preliminary exploration of the artificial preparation, structures and properties of regenerated silk fibers