Abstract:This article presents a 39 GHz transceiver front-end chipset for 5G multi-input multi-output (MIMO) applications. Each chip includes two variable-gain frequency-conversion channels and can support two simultaneous independent beams, and the chips also integrate a local-oscillator chain and digital module for multi-chip extension and gain-state control. To improve the radio-frequency performance, several circuit-level improvement techniques are proposed for the key building blocks in the front-end system. Furthermore, an advanced low-temperature co-fired ceramic process is developed to package the 39 GHz dual-channel transceiver chipset, and it achieves low packaging loss and high isolation between the two transmitting (TX)/receiving (RX) channels. Both the chip-level and system-in-package (SIP)-level measurements are conducted to demonstrate the performance of the transceiver chipset. The measurement characteristics show that the TX SIP provides 11 dB maximum gain and 10 dBm saturated output power, while the RX SIP achieves 52 dB maximum gain, 5.4 dB noise figure, and 7.2 dBm output 1 dB compression point. Single-channel communication link testing of the transceiver exhibits an error vector magnitude (EVM) of 3.72% and a spectral efficiency of 3.25 bit·s−1·Hz−1 for 64-quadrature amplitude modulation (QAM) modulation and an EVM of 3.76% and spectral efficiency of 3.9 bit·s−1·Hz−1 for 256-QAM modulation over a 1 m distance. Based on the chipset, a 39 GHz multi-beam prototype is also developed to perform the MIMO operation for 5G millimetre wave applications. The over-the-air communication link for one- and two-stream transmission indicates that the multi-beam prototype can cover a 5–150 m distance with comparable throughput.

Millimeter-wave 0- &#x003c0; Phase Modulation Transceiver Module

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

An Ultra Broadband Passive Vector Modulator Phase Shifter

A 39 GHz Dual-Channel Transceiver Chipset with an Advanced LTCC Package for 5G Multi-Beam MIMO Systems

A 12-Mw 40–60-Ghz 0.18- $\mu {\hbox {m}}$ BiCMOS Oscillator-Less Self-Demodulator for Short-Range Software-Defined Transceivers

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A Millimeter T/R Modules with High-Gain and High Power

An Energy-Efficient 10-Gb/s CMOS Millimeter-Wave Transceiver with Direct-Modulation Digital Transmitter and I/Q Phase-Coupled Frequency Synthesizer

A Highly Integrated Energy-efficient CMOS Millimeter-wave Transceiver with Direct-modulation Digital Transmitter, Quadrature Phased-coupled Frequency Synthesizer and Substrate-Integrated Waveguide E-shaped Patch Antenna

A 60 Ghz Low Power Direct-Conversion Quadrature-Phase Transmitter In 130 Nm Cmos With Low Profile Cavity Backed Antenna

A Fully Integrated X-Band Phased-Array Transceiver in 0.13-Μm CMOS Technology

A 6–18 GHz GaAs multifunctional chip for transmit/receive modules

A Compact Hybrid G-band Heterodyne Receiver Integrated with Millimeter Microwave Integrated Circuits and Schottky Diode-Based Circuits

Design and performance of octave S/C band MMIC T/R modules for multi-function phased arrays

A Ku-Band Dual-Channel T/R MMIC Based on a 0.18-μm GaAs E/D pHEMT Technology

An RF Transmitter Front-End Implementation in 0.18&#x03bc;m CMOS for OFDM-UWB

A Ka-band Low Power Consumption MMIC Core Chip for T/R Modules

A 32–40 GHz 4-Channel transceiver with 6-bit amplitude and phase control

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

A Fully Integrated 27.5-30.5 GHz 8-Element Phased-Array Transmit Front-end Module in 65 nm CMOS

Millimeter-wave 0- &amp;#x003c0; Phase Modulation Transceiver Module