Abstract:Preformed fragments can deform or even fracture when subjected to contact blasts, which might lead to a reduction of the terminal effect. Therefore, to solve this problem, the effect of surface electroplating on the fragment deformation behavior under contact blasts was analyzed. Firstly, blast recovery tests were carried out on uncoated and coated fragments. After the contact blast, the two samples produced different deformation behaviors: the uncoated fragments were fractured, while the coated fragments maintained integrity. The tests were simulated by finite element simulation, and the deformation behavior of the different samples matched well with the test results, which can explain the protective effect of the coating after quantification. In order to further reveal the dynamic behavior involved, detonation wave theory and shock wave transmission theory in solids were used to calculate the pressure amplitude variation at the far-exploding surface of the fragments. The theoretical results showed that the pressure amplitude of the uncoated samples instantly dropped to zero after the shock wave passed through the far-exploding surface, which resulted in the formation of a tensile zone. But the pressure amplitude of the coated samples increased, transforming the tensile zone into the compression zone, thereby preventing the fracture of the fragment near the far-exploding surface, which was consistent with the test and simulated results. The test results, finite element simulations, and theories show that the coating can change the deformation behavior of the fragment and prevent the fracture phenomenon of the fragment. It also prevents the material from missing and a molten state of the fragment in the radial direction by microscopic observation and weight statistics.

Numerical Simulation Study on the Blast Loading Performance of Reactive Fragment

Research of Loading Effects of Blast in Air

Numerical simulation of the disk fragment impacting resistance of plate target

Probability Distribution and Determination of Blast Loading During Structural Blast Resistant Study

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Numerical Simulation Study on Impact Initiation on Shielded Charge Using Hypervelocity Composite-Structure Reactive Fragments

Numerical Simulation of the Effect of Blast Shock Wave on Target Plate

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Centrifuge Experiment and Numerical Analysis of an Air-Backed Plate Subjected to Underwater Shock Loading

Numerical Simulation of the Blast Wave of a Multilayer Composite Charge

Numerical Simulation of Kiewitt8 Single-Layer Reticulated Shell Subjected to Blast Loading

Numerical Simulation of Blasting Effect with Divided Charge Structure

PREDICTION OF DEBRIS LAUNCH VELOCITY OF REINFORCED CONCRETE SLAB SUBJECTED TO INTERNAL BLAST LOADING

Numerical Simulation and Experimental Study on Dynamic Response of the Buildings Structure under Blast Shock Wave

Experimental and Numerical Study of Non-Explosive Simulated Blast Loading on Reinforced Concrete Slabs

Research on the Buffering Effect of Flexible Material on the Explosive Loading

The Effect of Surface Electroplating on Fragment Deformation Behavior When Subjected to Contact Blasts

Numerical Research on Blast-resistant Performance of Graded Corrugated Sandwich Plates under Air Blast Loading

Numerical Study of Water Tank under Blast Loading

Numerical Investigation of Composite Laminate Subjected to Combined Loadings with Blast and Fragments

Numerical Investigation on Anti-Explosion Performance of Non-Metallic Annular Protective Structures