Abstract:This paper develops new insights into quantitative methods for the validation of computational model prediction. Four types of methods are investigated, namely classical and Bayesian hypothesis testing, a reliability-based method, and an area metric-based method. Traditional Bayesian hypothesis testing is extended based on interval hypotheses on distribution parameters and equality hypotheses on probability distributions, in order to validate models with deterministic/stochastic output for given inputs. Two types of validation experiments are considered - fully characterized (all the model/experimental inputs are measured and reported as point values) and partially characterized (some of the model/experimental inputs are not measured or are reported as intervals). Bayesian hypothesis testing can minimize the risk in model selection by properly choosing the model acceptance threshold, and its results can be used in model averaging to avoid Type I/II errors. It is shown that Bayesian interval hypothesis testing, the reliability-based method, and the area metric-based method can account for the existence of directional bias, where the mean predictions of a numerical model may be consistently below or above the corresponding experimental observations. It is also found that under some specific conditions, the Bayes factor metric in Bayesian equality hypothesis testing and the reliability-based metric can both be mathematically related to the p-value metric in classical hypothesis testing. Numerical studies are conducted to apply the above validation methods to gas damping prediction for radio frequency (RF) microelectromechanical system (MEMS) switches. The model of interest is a general polynomial chaos (gPC) surrogate model constructed based on expensive runs of a physics-based simulation model, and validation data are collected from fully characterized experiments.

A Contribution to Validating of Simulation Models in Production and Logistics

Model Validation Via Uncertainty Propagation and Data Transformations

Critical Problems in Validation Process of Simulation Models

A New Validation Metric for Models with Correlated Responses Using Limited Experimental and Simulation Data

Model Validation of Dynamic Engineering Models under Uncertainty

Quantitative model validation techniques: new insights

Research on Validation Method for Complex Simulation Systems

Knowledge-Based Method for the Validation of Complex Simulation Models

The Validation of A Microscopic Simulation Model: A Methodological Case Study

An empirical learning-based validation procedure for simulation workflow

Validation Research on Simulation Models

Validation method for simulation models with iteration operation

A Pattern-Based Validation Method for the Credibility Evaluation of Simulation Models.

Development of a Comprehensive Validation Method for Dynamic Systems and Its Application on Vehicle Design

An Evidence Theory-Based Validation Method for Models with Multivariate Outputs and Uncertainty

An Intelligent Validation System of Simulation Model

Research On Validation Metrics For Multiple Dynamic Response Comparison Under Uncertainty

Verifying and Validating a Simulation Model.

Methods of Validation of Model with Multivariate Outputs

Decision Tree Based Validation of Load Model Parameters