Abstract:The performance of propellants, explosives and pyrotechnics is known to benefit from the use of metallic alloys as fuel additives. Previous studies have shown that switching from pure Al to Al-Mg alloy can improve the agglomeration and combustion features of composite propellants. However, the optimal ratio of Al and Mg has yet to be explored. We experimentally examine the effects on ignition, combustion and agglomeration arising from substituting pure Al particles with four different Al-Mg alloys whose Mg content ranges from 10 to 60%. Using thermogravimetric−differential scanning calorimetry, we find that switching to Al-Mg alloy can enable oxidation to occur earlier and can increase the oxidation rate and the enthalpy of thermal reaction, which is found to be positively correlated with the Mg content. Using laser ignition measurements, we find that the addition of Mg can promote the ignition and combustion of Al, with (Al/Mg)0.5 exhibiting the most balanced combination of a high combustion intensity, a short ignition delay, and a high mass burning rate. Through high-pressure measurements taken at 1 to 7 MPa, we find that switching to Al-Mg alloy can increase the propellant burning rate (by nearly a factor of two) and the pressure exponent (from 0.23 to 0.43). We also find that the burning rate and pressure exponent are both highest for the propellant containing (Al/Mg)0.1, but that both quantities decrease with further increases in Mg content. High-speed microscopic surface imaging at 1 MPa reveals that increasing the Mg content can increase the overall combustion intensity of the propellant and decrease the diameter of spherical agglomerates, consistent with the observed size distribution of the condensed combustion products. From these measurements, it can be concluded that (Al/Mg)0.5 provides the optimal balance of ignition, combustion and agglomeration characteristics in the formulation of composite propellants containing Al-Mg alloy.

Effect of metal oxides on the light radiation intensity of Ba(NO3)2/Mg-containing pyrotechnic mixtures combustion

The Effect of CuO on the Thermal Behavior and Combustion Features of Pyrotechnic Compositions with AN/MgAl

Kinetics and Combustion Behavior of Atomized Zn-Mg Alloy Powder

OXIDIZER AND GAS-ENVIRONMENT EFFECTS ON AFTERBURNING REACTIONS AND EXPLOSION PERFORMANCES OF HMX-BASED THERMOBARIC EXPLOSIVES

Effect of Magnesium on the Burning Characteristics of Boron Particles

The effect of Mg(BH4)2 on the energy characteristics of RDX based aluminized explosives

Effect of pressure and oxygen content on the ignition and combustion of Al–Mg alloy

Effect of metal powders on explosion of fuel-air explosives with delayed secondary igniters

Modifying the ignition, combustion and agglomeration characteristics of composite propellants via Al-Mg alloy additives

Pyrotechnic Delay Compositions Based on BaO2: Not as "Green" as Expected

Enhancing the Emission Intensity and Decreasing the Full Widths at Half Maximum of Ba3Si6O12N2:Eu(2+) by Mg(2+) Doping.

Effect of different BaO contents on the photoluminescence properties of the Eu[math]-doped high thermal stability Sr[math]BaxMgSi2O8 phosphors

Effect of Ultrafine Al/B, Ti/B, and Fe/B Powders on the Ignition and Combustion Characteristics of High-Energy Materials

Effects of Mg Al Alloy Powder on the Combustion and Infrared Emission Characteristics of the Mg Al PTFE Viton Composition

Evaluation of the Combustion Properties and Catalytic Activity of MgAlB Energetic Ternary Particles

Effects of aluminum addition on flash ignition and combustion of boron nanoparticles

Study on Synergistic Radiation Yellow Light of Strontium Nitrate/Barium Nitrate-Based Illuminant

Study on combustion characteristics and pyrotechnic cutting effects of bimetal thermite Ni/Al/Fe2O3 system

Performance Improvement of NO<sub><i>x</i></sub>-Storage BaO/Al<sub>2</sub>O<sub>3</sub> by Using Barium Peroxide as the Precursor of BaO

Exploring the Influence of Metal Oxides on the Pyrolytic Behavior and Decomposition Mechanism of the Green Gas Generating Agent 5-Aminotetrazole

Performance Improvement of NO x -Storage BaO/Al 2 O 3 by Using Barium Peroxide as the Precursor of BaO