Abstract:Thin-walled bearings are widely used owing to the advantages of their light structure, high hardness, and strong load-carrying capacity. However, thin-walled bearings are often prone to deformation during the machining process, which can seriously affect the performance of the bearings. In addition, the machining deformation and quality of bearings are difficult to balance. To address the above issues, this paper investigates the effects of the machining parameters on the machining deformation, surface quality, and machining efficiency of a thin-walled bearing during the roughing stage. The dynamic balance between deformation inhibition and high quality in rough grinding was studied, and the optimal parameters for thin-walled bearing outer ring grinding were obtained. The deformation mechanism of thin-walled bearings caused by grinding was revealed through simulation and experimental analysis. The results show that the machining deformation and quality reach a balance when the workpiece speed is 55 r/min, the grinding wheel rotational speed is 2000 r/min, and the feed rate is 0.1 mm/min. Deformation increases with the increase in workpiece speed and grinding wheel speed. At the same time, the surface roughness increases with the increase in the workpiece speed, but the increase in the wheel speed will improve the surface roughness. As the workpiece speed increases, the surface topography shows a more pronounced stockpile of material, which is ameliorated by an increase in grinding wheel speed. As the rotational speed of the workpiece increases, the number of abrasive grains involved in the process per unit of time decreases, and the surface removal of the workpiece is less effective, while the increase in the rotational speed of the grinding wheel has the opposite effect. The grinding deformation of thin-walled bearings is mainly induced by machining heat and stress. As the rotational speed increases, the heat flux in the grinding zone increases. More heat flux flows into the surface of the workpiece, causing an increase in thermal stresses on the inner surface of the bearing collar, leading to greater deformation. The temperature in the grinding area can be reduced during machining, realizing a reduction in deformation. The research content contributes to the balance between high quality and low distortion in machining processes.

Investigation of Cutting Mechanism and Residual Stress State with Grooved Grinding Wheels

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Investigation on Grinding Temperature and Heat Flux Distribution with Grooved Grinding Wheels

Grooving and Grinding Performance of Structured Wheels Fabricated with Diamond Cutting Blades

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Investigation of the grinding temperature and subsurface quality of a novel point grinding wheel

Grinding performance integrated experimental evaluation on alumina ceramics with leaf-vein bionic grinding wheel

Towards Understanding Subsurface Characteristics in Burn Process of Gear Profile Grinding

Grooving Profile Control for Structured Grinding Wheels with Picosecond Pulsed Laser

Numerical and experimental investigation on grinding-induced exit burr formation

On the Tool Wear Behavior During Ultrasonic Vibration-Assisted Form Grinding with Alumina Wheels

Optimal Design and Performance Evaluation of Grinding Wheels with Triply Periodic Minimal Surface Lattice Structure

On the Grinding Performance of Alumina Wheels in Ultrasonic Vibration–assisted Grinding of Hardened GCr15 Steel

Grinding of alumina ceramic with microtextured brazed diamond end grinding wheels

Investigation on the Deformation and Surface Quality of a Bearing Outer Ring during Grinding Processing

Investigation of grindability and surface integrity in creep feed grinding of GH738 alloy using different grinding wheels

Systematic Monitoring and Evaluating the Wear of Alumina Wheel When Grinding the Workpiece of Cr12

Interference and grinding characteristics in ultra-precision grinding of thin-walled complex structural component using a ball-end grinding wheel

Theoretical and Experimental Research on Generation Mechanism of Grinding Wheel Topography by Laser Dressing and 3D Laser Scanning

Damage evolution and removal behaviors of GaN crystals involved in double-grits grinding

No-impact trajectory design and fabrication of surface structured CBN grinding wheel by laser cladding remelting method