Abstract:Abstract The Circular Electron Positron Collider (CEPC) has been proposed as a Higgs and a high luminosity Z factory in the last few years. The baseline detector concept design consists of a Time Projection Chamber (TPC) as the main tracker detector, which needs the high precision spatial resolution of approximately 100 μm in rφ direction over the whole the drift length. There will be no power-pulsing mode in the future circular colliders, the specific limitations of the detector requirements should be considered at the high luminosity Z pole. Several critical issues remain regarding the TPC R&D. The physics goals require particle identification (PID) resolution to be considered using the cluster counting method. The updated simulation results of the PID resolution demonstrate the potential of TPC technology to fit Z-pole running at CEPC. To meet the physics requirements for the tracker detector in CEPC, a TPC prototype integrated with an ultraviolet laser track system has been developed. The prototype consists of several horizontal laser tracks around the TPC detector chamber with a drift length of 500 mm, the fast electronics readout of 1280 channels, a 20000 V field-cage, a double-layer GEM detector with 200 × 200 mm 2 active area and a DAQ system. The spatial resolution, dE/dx resolution, and drift velocity were studied and analyzed using the TPC prototype and the 266 nm UV laser tracks. Some updated experimental results, including the spatial resolution, the laser track reconstruction, and dE/dx resolution have been obtained. By using the pseudo full-length track to evaluate the full-size TPC with 220 layers at CEPC, the dE/dx resolution was estimated to be about 3.4%. All results indicates that this TPC prototype integrated with UV laser tracks has been successfully developed to meet the updated CEPC physics requirements.

Reconstructing K^0_S and in the CEPC baseline detector

Reconstructing $$K^0_S$$ and $$\varlambda $$ in the CEPC Baseline Detector

Measurement of H → Μ + Μ − Production in Association with a Z Boson at the CEPC

Beam test of a baseline vertex detector prototype for CEPC

Cross Section and Higgs Mass Measurement with Higgsstrahlung at the CEPC

Measurements of decay branching fractions of the Higgs boson to hadronic final states at the CEPC

Performance of the continuous ions suppression TPC prorotype for circular collider

Feasibility Study of TPC Tracker Detector for the Circular Collider

Study of K-S(0) Reconstruction and Lifetime Measurement at Bes Ii

Analysis of B C → Τν Τ at CEPC

Production of hidden-heavy and double-heavy hadronic molecules at the $Z$ factory of CEPC

Testing Bell inequalities and probing quantum entanglement at CEPC

Simulation and reconstruction of particle trajectories in the CEPC drift chamber

Status and prospects of TPC module and prototype at high luminosity <i>Z</i> physics on CEPC

H→e+e−at the CEPC: Initial State Radiation Effect with MadGraph

Erratum: Development of Time Projection Chamber prototype integrated with UV laser tracks for the future circular e<sup>+</sup>e<sup>-</sup> collider

Probing dark matter particles at CEPC

The Status of CEPC

The Physics potential of the CEPC. Prepared for the US Snowmass Community Planning Exercise (Snowmass 2021)

Progress of High Precision TPC Detection Technology for the Future Circular E+e-Collider

Searching for the light leptophilic gauge boson Z x via four-lepton final states at the CEPC