Abstract:Wind tunnel experiments were carried out to study the effects of surface roughness on the turbulent boundary layer flow over a two-dimensional steep hill, accompanied by a relatively steady and large separation, sometimes called a separation bubble. Rough surface conditions were modeled by placing small cubes on the hill surface with an arrangement whose roughness density equaled 4.1%. Vertical profiles of the turbulence statistics over the hill were investigated, and compared with those for an oncoming turbulent boundary layer over a flat surface covered by cubes with the same arrangement. Furthermore, measurements of the turbulent boundary layer flow over a smooth hill of the same shape were taken in order to identify the surface roughness effects. The speed-up ratio above the crest and the turbulence statistics in the wake were focused on. Flow structures in the separation bubble were investigated by measuring the velocity with a split-fiber probe. Measurement with fine resolution in the streamwise direction for near-ground flows was carried out to detect the reattachment point. The results show that the roughness blocks both on the hill surface and on the upstream ground affect the speed-up ratio over the hill. The speed-up ratio above the crest of a rough hill is larger than that of a smooth hill. The separation bubble of a rough hill extends further downstream, resulting in a larger reattachment length than a smooth hill. The location with the maximum turbulence intensity in the downstream profile also moves further downstream for a rough hill. Profiles of reverse-flow intermittency that give a description of the dynamic behavior of the separation bubble are presented. In addition, variations of power spectrum of longitudinal velocity fluctuation downstream of the hill are shown for both surface conditions.

LES Study of Turbulent Boundary Layer over a Smooth and a Rough 2D Hill Model

Numerical Study on Turbulent Boundary Layers over Two-Dimensional Hills - Effects of Surface Roughness and Slope

Constrained Large-Eddy Simulation of Turbulent Flow over Inhomogeneous Rough Surfaces

Les and Cdns Investigation of T106c Low Pressure Turbine

LES Study of Turbulent Flow Fields over Hilly Terrains - Comparisons of Inflow Turbulence Generation Methods and SGS Models

LES Study of Turbulent Flow Fields over a Smooth 3-D Hill and a Smooth 2-D Ridge

Experimental Study on Roughness Effects on Turbulent Boundary Layer Flow over a Two-Dimensional Steep Hill

Numerical Study of Unsteady Wake Flows over A Hill for the Oncoming Boundary-Layer Turbulence

Large Eddy Simulation of Flow Past a Square Cylinder Based on Dynamic Sub-Grid Scale Models

Large-Eddy Simulations of the Flow over an Isolated Three-Dimensional Hill

Large-eddy simulation of upwind-hill effects on wind-turbine wakes and power performance

Effects of Roughness Blocks on Atmospheric Boundary Layer Flow over a Two-Dimensional Low Hill With/without Sudden Roughness Change

LES study of topographical effects of simplified 3D hills with different slopes on ABL flows considering terrain exposure conditions

Large-eddy Simulation of Separated Turbulent Flows over a Three-Dimensional Hill Using WRF and OpenFOAM

Assessment of Turbulence Model Effects on WRF-LES of Separated Turbulent Flows Past a 3D Hill

Large-eddy Simulation of Wind-Turbine Wakes over Two-Dimensional Hills

Detached Eddy Simulation of Turbulent Flow Fields over Steep Hilly Terrain

Effects of advection schemes and numerical stabilization filters on separated turbulent flows past a three-dimensional hill using WRF-LES

Turbulent Flow Simulation Using Les with Dynamical Mixed One-Equation Subgrid Models in Complex Geometries

Numerical Study of the Flow Characteristics of Downburst-like Wind over the 3D Hill Using Different Turbulence Models

Embedded large eddy simulation of boundary layer transition behind a micro-ramp