Abstract:Excitation-emission matrix spectroscopy (EEMs) was widely used in food science, analytical chemistry, biochemistry and environmental science because of its wealth of information and high sensitivity. However, the Rayleigh and Raman scatterings bring difficulties to display data and quantitative analysis of EEMs. Therefore, in the early stage of data processing, eliminating the scatterings' interference is significant for the popularization and application of EEMs. In previous studies, few researchers aimed to deal with the low-concentration solution and the scattering peaks overlap with the material fluorescence signals. In order to solve this problem, the paper proposed a self-adapting method to remove the scatterings of EEMs. First, the method corrects the Raman scatterings and background interference by subtracting the spectral baseline of the solvent obtained in each experiment. Then, according to the intensity and overlap degree of fluorescence signals and scattering peaks. EEMs are divided into five categories corresponding to three overlap levels: no overlap, weak overlap and serious overlap. The Rayleigh scatterings are corrected by setting to zero, piecewise cubic Hermite interpolation polynomial algorithm and Gaussian-piecewise cubic Hermite interpolation polynomial coupling algorithm, respectively. The method is based on one-dimensional interpolation, and only emission spectrums are studied, reducing the algorithm's complexity and computation time. The method's effectiveness was demonstrated by the experiments on four typical organic compounds: Tyrosine, Fulvic acid, Naphthalene acetic acid and Rhodamine B. Moreover, compared with the Delaunay interpolation method, which is most used in current research. The concentration regressions are performed with the EEMs after the scatterings' correction; the average of -R-squared obtained by the method is 0.9962, which is 5.04% higher than the Delaunay interpolation method. At the same time, by comparing the EEMs of Fulvic acid corrected by the method and Delaunay interpolation method, it is proved that this method can better maintain the structural characteristics of the fluorescence spectral regions and effectively avoid the occurrence of overfitting. Finally, this method is used to monitor the simulated sudden pollution water samples, which verifies that the method has good universality and practical application value. It provides a novel idea for removing scatterings' interference of EEMs.

Using Rayleigh Scattering to Correct the Inner Filter Effect of the Fluorescence Excitation-Emission Matrix.

A Self-Adapting Method for Removing Scatterings in the Excitation-Emission Matrix Spectroscopy

Rayleigh scattering correction for fluorescence spectroscopy analysis

Adaptive handling of Rayleigh and Raman scatter of fluorescence data based on evaluation of the degree of spectral overlap

An Enhancement Approach of Fluorescence Signatures in Excitation Emission Matrixes for Water Contaminant Analysis.

Front-face Fluorescence Excitation-Emission Matrix (FF-EEM) for Direct Analysis of Flocculated Suspension Without Sample Preparation in Coagulation-Ultrafiltration for Wastewater Reclamation

A Novel Method to Handle Rayleigh Scattering in Three-Way Excitation-Emission Fluorescence Data

A UV-visible absorption spectrum denoising method based on EEMD and an improved universal threshold filter

An open‐source code for Mie extinction extended multiplicative signal correction for infrared microscopy spectra of cells and tissues

Extracting Chemical Information from Spectral Data with Multiplicative Light Scattering Effects by Optical Path-Length Estimation and Correction.

Correcting Thermal-Emission-induced Detector Saturation in Infrared Spectroscopy

Quantitative Fret Measurement Using Emission-Spectral Unmixing with Independent Excitation Crosstalk Correction

Correction methods of Rayleigh scatter of fluorescence excitation-emission spectra in marine phytoplankton

Removal of First-Order Rayleigh Scatter Nonlinear Interference in Multi-Way Calibration of Excitation-Emission Matrix Fluorescence Spectra with the Use of Trilinear Decomposition Methods

High-throughput fluorescence quantification method based on inner filter effect and fluorescence imaging analysis

Separating Reflective and Fluorescent Components Using High Frequency Illumination in the Spectral Domain

A Review On The Methods For Correcting The Fluorescence Inner-Filter Effect Of Fluorescence Spectrum

Fluorescence Approach for the Determination of Fluorescent Dissolved Organic Matter.

Quantitative Fret Measurement by High-Speed Fluorescence Excitation and Emission Spectrometer

The Correction Fluorescence Inner Filter Effect Using a Single Excitation and Dual-Emission Fiber Optic Probe.

Inner filter effect in fluorescence spectroscopy: As a problem and as a solution