Abstract:Ride comfort is an important indicator to evaluate the dynamic performance of automotive vehicles. One method for improving ride comfort is to incorporate an active actuator into the passive suspension. However, the improvement is closely linked with the required actuation power and force. Increased actuation requirements may lead to higher energy consumption and a larger actuator size. To enhance the trade-off between ride comfort and active actuation requirements, a new design approach for searching for the optimal passive-active-combined suspension across many different mechanical component layouts incorporating an inerter is proposed in this paper. Compared with traditional designs where the suspension is limited to a few special layouts, via this approach the optimal passive part among all network possibilities with pre-determined numbers of each element type (springs, dampers and inerters), and optimal controller parameters of the parallel active actuator can be identified. Considering a quarter-car model, with a benchmark combined active-passive suspension in which the passive part is a spring-damper, the optimal inerter-based suspension can reduce the active force by more than 48% and regenerate 6 W more average power in the active part while achieving the same ride comfort. Note that in this case, two constraints are always considered: the road-holding ability (as indicated by the dynamic tyre load) and suspension travel of the identified suspension will not be worse than those of the benchmark suspension. The optimal trade-off obtained with this approach serves as a powerful tool in the automotive suspension design as it provides guidance on the following three aspects: the optimal ride comfort, the minimum power consumption and the feasibility of specific actuation requirements, where the second point is obtained in conjunction with the power conservation theorem proposed in this paper which proves that the total power consumed by the passive and active parts will not vary with changes in the passive part and active controller parameters.

Influence of Nonlinear Characteristics of Planetary Flywheel Inerter Actuator on Vehicle Active Suspension Performance

Design and Research of a Linear Actuator for Electric Vehicle Active Suspension

Modeling, Testing, and Characteristic Analysis of a Planetary Flywheel Inerter

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Performance Analysis of a New Hydropneumatic Inerter-Based Suspension System with Semi-Active Control Effect

Using an inerter to enhance an active-passive-combined vehicle suspension system

Performance enhancements of semi-active vehicle air ISD suspension

Design and Characteristics Analysis of Ball Screw Type Inerter with Planetary Flywheel

Design, Parameter Optimisation, and Performance Analysis of Active Tuned Inerter Damper (TID) Suspension for Vehicle

Dynamic Performance Analysis of Semiactive Vehicle ISD Suspension Based on the Power-Driven-Damper Strategy

Research on Inertial Force Attenuation Structure and Semi-Active Control of Regenerative Suspension

Phase deviation of semi-active suspension control and its compensation with inertial suspension

Design optimization of variable inerter based on vehicle suspension performance criteria

On Fuzzy Control Strategy of Nonlinear Semi-Active Suspension System

Model Predictive Thrust Force Control for Linear Motor Actuator used in Active Suspension

Enhancing the trade-off between ride comfort and active actuation requirements via an inerter-based passive-active-combined automotive suspension

Vehicle active ISD-DVA suspension system

Design and experiment study of a semi-active energy-regenerative suspension system

Electromagnetic Field and Variable Inertia Analysis of a Dual Mass Flywheel Based on Electromagnetic Control

Design and experimental verification of self-powered electromagnetic vibration suppression and absorption system for in-wheel motor electric vehicles

Vibration Performance Optimization of the Semi-Active Suspension with Fuzzy Control Method