Abstract:Electrochemical CO2 reduction on Cu is a promising approach to produce value-added-chemicals using renewable feedstocks, yet various Cu preparations have led to differences in activity and selectivity towards single and multi-carbon products. Here, we find, surprisingly, that the effective catalytic activity towards ethylene improves when there is a larger fraction of less active sites acting as reservoirs of *CO on the surface of Cu nanoparticle electrocatalysts. In an adaptation of chemical transient kinetics to electrocatalysis, we measure the dynamic response of a gas diffusion electrode (GDE) cell when the feed gas is abruptly switched between Ar (inert) and CO. When switching from the Ar to CO, CO reduction (COR) begins promptly, but when switching from CO to Ar, COR can be maintained for several seconds (delay time), despite the absence of the CO reactant in the gas phase. A three-site microkinetic model captures the observed dynamic behavior and shows that Cu catalysts exhibiting delay times have a less active *CO reservoir that exhibits fast diffusion to active sites. The observed delay times and the estimated *CO reservoir sizes are affected by catalyst preparation, applied potential, and microenvironment (electrolyte cation identity, electrolyte pH, and CO partial pressure). Notably, we estimate that the *CO reservoir surface coverage can be as high as 88±7% on oxide-derived (OD-Cu) at high overpotentials (-1.52 V vs. SHE) and that increases in reservoir coverage coincide with increased turnover frequencies to ethylene. We also estimate that *CO can travel substantial distances (up to 10s of nm) prior to desorption or reaction. It appears that active C-C coupling sites, by themselves, do not control selectivity to C2+ products in electrochemical COR; the supply of CO to those sites is also a crucial factor. More generally, the overall activity of Cu electrocatalysts cannot be approximated from linear combinations of individual site activities. Future designs must consider the diversity of the catalyst network and account for inter-site transportation pathways.

Experimental Evidence of Distinct Sites for CO2-to-CO and CO Conversion on Cu in the Electrochemical CO2 Reduction Reaction

Experimental evidence of distinct sites for CO 2 -to-CO and CO conversion on Cu in the electrochemical CO 2 reduction reaction

Revealing the Nature of C-C Coupling Sites on a Cu Surface for CO2 Reduction

Role of Subsurface Oxygen on Cu Surfaces for CO2 Electrochemical Reduction

Identification of Cu(100)/Cu(111) Interfaces As Superior Active Sites for CO Dimerization During CO2 Electroreduction.

Co2 Reduction On Cu At Low Overpotentials With Surface Enhanced In Situ Spectroscopy

Identification of Cu(100)/Cu(111) Interfaces as Superior Active Sites for CO Dimerization During CO 2 Electroreduction

Cation-Dependent Impact of CO2 on Cu-Catalyzed Electrochemical CO Reduction Reaction

Mechanistic Implications of Low CO Coverage on Cu in the Electrochemical CO and CO2 Reduction Reactions

Controllable Cu0‐Cu+ Sites for Electrocatalytic Reduction of Carbon Dioxide

CO electroreduction on single-atom copper

C-C Coupling Is Unlikely to Be the Rate-Determining Step in the Formation of C2+ Products in the Copper-Catalyzed Electrochemical Reduction of CO

In Situ Infrared Spectroscopic Evidence of Enhanced Electrochemical CO2 Reduction and C-C Coupling on Oxide-Derived Copper

Speciation of Cu Surfaces During the Electrochemical CO Reduction Reaction.

H and CO Co-induced Adatom Formation on Cu in CO2 Electroreduction Conditions

Identification of Cu0/Cu+/Cu0 interface as superior active sites for CO2 electroreduction to C2+ in neutral condition

Dual-Atomic Cu Sites for Electrocatalytic CO Reduction to C2+ Products

Disentangling Distinct Cu Surface Sites for Electrocatalytic CO 2 -to-co and CO-to-C 2+ Conversion

Interstitial carbon induces enriched Cuδ+ sites in Cu2O nanoparticles to facilitate CO2 electroreduction to C2+ products

Theoretical study on CO production mechanism from CO 2 reduction on Cu–catalyst surface with different oxidation states

Importance of Site Diversity and Connectivity in Electrochemical CO Reduction on Cu