Abstract:This study presents a scroll expander modelling methodology for small scale power generation systems by combining scroll geometry and semi-empirical model. Although the semi-empirical model is quite popular, its dependence on several experimentally-determined scroll geometrical and operational parameters makes this approach inflexible for different capacities and operating conditions. Some studies have sought to improve its flexibility in terms of using different working fluids and more accurate empirical parameters, however, those improved models still depend on a considerable number of experimentally-obtained scroll parameters. Therefore, in this study, a practical methodology for a simpler semi-empirical model combined with the operational flexibility of the scroll geometry is presented. Firstly, the flow rates of mainstream and leakage flows are analysed, where a correlation between scroll clearance and pressure ratio is determined. Secondly, a simpler approach to the semi-empirical model of scroll expander is proposed, whereby dependent parameters have been reduced to two parameters by using scroll geometrical calculations. The model is further improved to predict the rotational speed and electricity output by considering the overall friction coefficient of the coupled expander-generator unit. The findings are then compared with the results of an experimental study. The results show that the effective clearance values between scrolls vary according to pressure ratios, increasing from 20μm to 34μm. Mass flow rate can be predicted within 10% deviation from the experimental results for the same inlet conditions and rotational speed at a transient state. Additionally, considering steady state conditions, modelling results show that the rotational speed and electricity output can also be predicted within 8% and 7.5% of deviation, respectively.

Simulation on Starting Procedure of Scroll Expander Driven by Compressed Air

Simulation and Experiment Research on Wide Ranging Working Process of Scroll Expander Driven by Compressed Air

Research on the performance characteristics of an oil-free scroll expander that is applied to a micro-scale compressed air energy storage system

Simulation of the Dynamic Processes in A Scroll Expander-Generator Used for Small-Scale Organic Rankine Cycle System

Experimental Investigation on the Performance of the Scroll Expander under Various Driving Cycles

Evaluate the validity of the empirical correlations of clearance and friction coefficients to improve a scroll expander semi-empirical model

Simulation of Scroll Expander Used in Low-Temperature Waste Heat Recovery System

Mathematical Modeling of Scroll Refrigeration Compressors

Transient flow and thermodynamics analysis of a scroll compressor based on CFD

Simulation of Dynamic Characteristics of Moving Magnet Linear Compressor for Refrigerator

A Simulation Method for GM-type Helium Compressors

An Improved Geometric Theoretical Model and Throughflow Prediction Method for a CO2 Scroll Compressor of Automotive Air Conditioning System

Bleed air CFD modelling in aerodynamic simulation of A heavy duty gas turbine compressor

Modelling and Analysis of the Start-Up Phase of a Compressed Air Energy Storage System under Variable Operating Conditions

Thermodynamic Simulation of Scroll Compressor/Expander Module in Automotive Fuel Cell Engine

Experimental Investigation of a Scroll Expander for Power Generation Part of a Resorption Cogeneration

Analysis of the transient flow in a scroll-type compressor constructed from an algebraic spiral with pressure relief valves

Three Dimensional Numerical Simulation of Discharge Flow in a Scroll Air Compressor

Analytical modeling of thermodynamic process for scroll compressor with back pressure optimization

A Computationally Efficient Scroll Compressor Model for Both Single-Phase and Two-Phase Compression Considering Scroll Wrap Temperature Distribution

Theoretical and Experimental Research on Scroll Expander Used in Small-Scale Organic Rankine Cycle System