Abstract:The efficiency of a thermoelectric (TE) generator for the conversion of thermal energy into electrical energy can be easily but roughly estimated using a constant properties model (CPM) developed by Ioffe. However, material properties are, in general, temperature (T)-dependent and the CPM yields meaningful estimates only if physically appropriate averages, i.e., spatial averages for thermal and electrical resistivities and the temperature average (TAv) for the Seebeck coefficient (α), are used. Even though the use of αTAv compensates for the absence of Thomson heat in the CPM in the overall heat balance, we find that the CPM still overestimates performance (e.g., by up to 6% for PbTe) for many materials. The deviation originates from an asymmetric distribution of internally released Joule heat to either side of the TE leg and the distribution of internally released Thomson heat between the hot and cold side. The Thomson heat distribution differs from a complete compensation of the corresponding Peltier heat balance in the CPM. Both effects are estimated quantitatively here, showing that both may reach the same order of magnitude, but which one dominates varies from case to case, depending on the specific temperature characteristics of the thermoelectric properties. The role of the Thomson heat distribution is illustrated by a discussion of the transport entropy flow based on the α(T) plot. The changes in the lateral distribution of the internal heat lead to a difference in the heat input, the optimum current and thus of the efficiency of the CPM compared to the real case, while the estimate of generated power at maximum efficiency remains less affected as it is bound to the deviation of the optimum current, which is mostly <1%. This deviation can be corrected to a large extent by estimating the lateral Thomson heat distribution and the asymmetry of the Joule heat distribution. A simple guiding rule for the former is found.

Efficiency of Inhomogeneous Thermoelectric Generators

Unique Temperature Distribution and Explicit Efficiency Formula for One-Dimensional Thermoelectric Generators under Constant Seebeck Coefficients

Relationship between thermoelectric figure of merit and energy conversion efficiency

Effect of Convection Heat Transfer on Performance of Waste Heat Thermoelectric Generator

Inhomogeneously doped thermoelectric nanomaterials

The thermoelectric conversion efficiency problem: Insights from the electron gas thermodynamics close to a phase transition

Parametric Study of Thermoelectric Power Generators under Large Temperature Difference Conditions

Inhomogeneous thermal conductivity enhances thermoelectric cooling

Thermoelectric Device Performance Beyond Average ZT: Holistic Consideration of Materials and Design

Study of Thermal Insulation Materials Influence on the Performance of Thermoelectric Generators by Creating a Significant Effective Temperature Difference

Modeling of Thermoelectric Generators with Effects of Side Surface Heat Convection and Temperature Dependence of Material Properties

Contribution of the distributed Peltier effect to the efficiency of the thermoelectric cooler branch

Performance evolution of thermoelectric modules under constant heat flux

Grading studies for efficient thermoelectric devices using combined 1D material and device modeling

Efficiency Enhancement in Ocean Thermal Energy Conversion: A Comparative Study of Heat Exchanger Designs for Bi2Te3-Based Thermoelectric Generators

Maximum power and the corresponding efficiency for a Carnot-like thermoelectric cycle based on fluctuation theorem

Power and efficiency factors for comprehensive evaluation of thermoelectric generator materials

Elucidating modeling aspects of thermoelectric generator

Advances in Thermoelectrics

Discrepancy between Constant Properties Model and Temperature-Dependent Material Properties for Performance Estimation of Thermoelectric Generators

Numerical Simulations on the Temperature Gradient and Thermal Stress of a Thermoelectric Power Generator