Status of the China Material Irradiation Facility RFQ
Chenxing Li,Weilong Chen,W. Dou,Zheng Gao,Yuan He,G. Huang,C. G. Li,L. Lu,W. Ma,A. Shi,Longbo Shi,Liepeng Sun,Feng-Feng Wang,Wenbin Wang,Zhi-jun Wang,Qi Wu,Xianbo Xu,Lei Yang,P. Yu,Bin Zhang,Junhui Zhang,Peng Zhang,T. Zhu
DOI: https://doi.org/10.18429/JACoW-LINAC2018-THPO053
2019-01-01
Abstract:The pulsed high power test and beam test of the China Material Irradiation Facility RFQ have been implemented. Before this, the radio frequency measurements and tuning are performed. In this paper, the processes and results of the radio frequency measurements, tuning, pulsed high power test and beam test will be presented. The results of tests are in good agreement with the design. INTRODUCTION Material study is important for the fusion energy utilization. It is important to construct accelerator-based neutron sources for verification of materials candidate to fusion reactor. The IFMIF project is a part of ITER project for this purpose. As counterpart to CFTER, the CMIF project is proposed. As a key equipment of CMIF, the RFQ is designed to accelerate 10 mA CW deuteron beam from 20 keV/u to 1.5 MeV/u. The design procedure is expatiated in references [1] and [2]. The key parameters are listed in Table1. Table 1: Parameters of CMIF RFQ Parameters Values Particle D+ Frequency (MHz) 162.5 Energy (I/O, MeV/u) 0.02/1.55 Beam current (mA) 10 Cavity length (m) 5.34 Inter-vane Voltage(kV) 65 Kilpatrick factor 1.4 Transmission efficiency (%) 98.9 TUNING OF CMIF RFQ Fabrications of single modules were completed May 2017. And assembly of whole length cavity is completed during July 2017. Rf measurements and tuning of the RFQ was carried out during July and August. The tuning process was expatiated in references [3]. The tuning was implemented by utilizing 100 slug tuners. Owe to the utilization of PISLs, the dipole perturbative components are below 1% during tuning, so there is no need for tuning of dipole perturbative components. Therefore, the lengths of tuners with same longitudinal position will be set to the same length. The evolution of the lengths of tuners is plot in Fig. 1. The quadrupole perturbative component during tuning is measured and plot in Fig. 2. Figure 1: Evolution of lengths of slug tuner groups. Figure 2: Evolution of the quadrupole perturbative component during tuning. Figure 3: The measured perturbative components after the assembly of copper slug tuners. ___________________________________________ * Work supported by the National Magnetic Confinement Fusion Science Program of China (Grant No. 2014GB104001) and the National Natural Science Foundation of China (Grant No. 91426303). † email address: lichenxing@impcas.ac.cn 29th Linear Accelerator Conf. LINAC2018, Beijing, China JACoW Publishing ISBN: 978-3-95450-194-6 ISSN: 2226-0366 doi:10.18429/JACoW-LINAC2018-THPO053 Proton and Ion Accelerators and Applications
Materials Science