Abstract:Lead zirconate titanate (PbZrxTi1-xO3, or PZT) is a piezoelectric material widely used as sensors and actuators. For microactuators, PZT often appears in the form of thin films to maintain proper aspect ratios. One major challenge encountered is accurate measurement of piezoelectric coefficients of PZT thin films. In this paper, we present a simple, low-cost, and effective method to measure piezoelectric coefficient d33 of PZT thin films through use of basic principles in mechanics of vibration. A small impact hammer with a tiny tip acts perpendicularly to the PZT thin-film surface to generate an impulsive force. In the meantime, a load cell at the hammer tip measures the impulsive force and a charge amplifier measures the responding charge of the PZT thin film. Then the piezoelectric coefficient d33 is obtained from the measured force and charge based on piezoelectricity and a finite element modeling. We also conduct a thorough parametric study to understand the sensitivity of this method on various parameters, such as substrate material, boundary conditions, specimen size, specimen thickness, thickness ratio, and PZT thin-film material. Two rounds of experiments are conducted to demonstrate the feasibility and accuracy of this new method. The first experiment is to measure d33 of a PZT disk resonator whose d33 is known. Experimental results show that d33 measured via this method is as accurate as that from the manufacturer's specifications within its tolerance. The second experiment is to measure d33 of PZT thin films deposited on silicon substrates. With the measured d33, we predict the displacement of PZT thin-film membrane microactuators. In the meantime, the actuator displacement is measured via a laser Doppler vibrometer. The predicted and measured displacements agree very well validating the accuracy of this new method.

Experimental Study on the Relationship Between PZT Excitation Voltage and Testing Sensitivity of Coating Structures by Electro-Mechanical Impedance Method

Lift-off Nulling and Internal State Inspection of Multi-Layer Conductive Structures by Combined Signal Features in Pulsed Eddy Current Testing

Optimum PZT Patch Size for Corrosion Detection in Reinforced Concrete Using the Electromechanical Impedance Technique

AN EXPERIMENTAL INVESTIGATION INTO THE COMPLEX ELECTROMECHANICAL BEHAVIOR OF PZT53

Effect of Lateral Pressure on the Non-Linear Behaviour of Pzt Ceramics

High-frequency Emi Signatures for Damaged Plates Using Finite Element Method

Development of a High-Power Testing System for Piezoelectric Ceramic Material

Dynamic Testing of Micro Devices Using Pzt Base Excitation

Measurement of Transverse Piezoelectric Coefficients of Pb(Zr0.52Ti0.48)O3 Thin Films by a Mechano-electrical Multiphysics Coupling, Bulge Test Method

Effects of Bias Voltage and Target Current on Microstructure and Load Measurement Performance of ZnO Piezoelectric Coatings Applied to Bolt in Transformer

Application of Emi Technique for Crack Detection in Continuous Beams Adhesively Bonded with Multiple Piezoelectric Patches

A proof of concept study on reliability assessment of different metal foil length based piezoelectric sensor for electromechanical impedance techniques

Measurements of Piezoelectric Coefficient d33 of Lead Zirconate Titanate Thin Films Using a Mini Force Hammer

Frequency Response Evaluation as Diagnostic and Optimization Tool for Pulsed Unipolar Plasma Electrolytic Oxidation Process and Resultant Coatings on Zirconium

A PZT-Based Electromechanical Impedance Method for Monitoring the Soil Freeze–Thaw Process

Strain Rate and Porosity Effect on Mechanical Characteristics and Depolarization of Porous Poled PZT95/5 Ceramics

High-field complex parameters characterization of PMN-PT single crystal/epoxy 1–3 composites ( φ = 0.4) under a high AC electric field with a varied intensity

Experimental and numerical investigation of the bonding conditions of piezoelectric sensors under high compressive strains on structures

Study of mechanical-magnetic and electromagnetic properties of PZT/Ni film systems by a novel bulge technique

Interpretation of Electrochemical Impedance Spectroscopy in Coating/Metal System by Cr Transmission Line Model

Health Monitoring of Steel Structures Using Impedance of Thickness Modes at Pzt Patches