Abstract:The importance of reducing ship resistance is growing considerably as a result of the increase in atmospheric emissions and the drive towards green shipping through decarbonization. Until this point, Energy Saving Devices (ESD), in particular, Hull Vane® (HV), have been widely applied as a potential technique for reducing wave-making resistance for vessels with higher Froude Number ( Fr ). The advantages of HV for a medium-speed vessel, where the wave-making component accounts for almost 50% of total resistance, have yet to be investigated. This study presents the computational analysis of the KCS model (1: 75.5); for a particular trim condition by using the VOF method and RANS solver. The hull acts as a candidate vessel for the class of medium-speed characteristics. A total of 36 numerical simulations were carried out to study the changes in resistance and motion characteristics of the vessel with and without HV. To validate the numerical setup, the experimental work of Hou et al (2020) on the DTMB hull was used. The effectiveness of HV can be comprehended by the reduction percentage in total resistance, trim, sinkage, and transom wave height, in comparison to bare hull condition. The reduction in total resistance extends up to 6% for Fr = 0.32 with configuration 2 with negative AoF. The CFD results indicate that there is a reduction in trim up to 57% for the maximum speed with a corresponding Fr = 0.34 with a positive angle of foil (AoF). The trim correction effect is increasing with the depth of submergence of HV. Concerning sinkage, there occurs nearly a 31% reduction for Fr = 0.34 with a positive AoF. There exists a substantial reduction in the height of the transom wave with the inclusion of HV, the results of which are discussed in detail. From the presented results, retrofitting the Hull Vane® is effective in the selected speed range but pronouncing as the speed of the vessel increases.

LCG Effects on Resistance Performance of a Planing Hull in Calm Water

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Numerical calculation and analysis of resistance performance of planing craft combining Savitsky method and overset grid technology

Numerical and Experimental Study on A 2-D Floating Body under Extreme Wave Conditions

A Study on Hydrodynamic Characteristics of a Planing Hull by CFD Simulation and Modified M-S Method

Investigation on the Resistance of Planing Hulls Based on a New Mathematical Model

Numerical Investigation on the Cavity Behavior and Hydrodynamic Performance of a Planing Air Cavity Ship

Experimental and Numerical Investigation on the Resistance Characteristics of a High-Speed Planing Catamaran in Calm Water

Research on Mesh Generation Effecting Resistance Calculation

Hull Gesture and Resistance Prediction of High-Speed Vessels

Numerical Investigation on Steady Wave of High-Speed Ship with Transom Stern by Potential Flow and CFD Methods

Numerical Study on Transom Stern Ventilation and Resistance of High-Speed Ship in Calm Water

Drift test analysis of a conventional planing hull utilising CFD and 2D+t models

Research on Factors of a Flow Field Affecting Catamaran Resistance Calculation

Planing Hull Hydrodynamic Performance Prediction Using LincoSim Virtual Towing Tank

CFD Investigation on the Hydrodynamic Loads and Motions when Ship Maneuvers in Regular and Irregular Waves

Computational Analysis of the Effect of Hull Vane on Hydrodynamic Performance of a Medium-speed Vessel

Numerical Study of Resistance Performance of Super-Slender Catamaran in High Speed

CFD verification and analysis of added resistance and motions of KVLCC2 in head waves

CFD simulations of ship maneuvering motion

A revisited verification and validation analysis for URANS simulation of planing hulls in calm water