Abstract:Gas insulated metal enclosed switchgear(GIS) and transmission line (GIL) have basically the same basin insulators which are used for gas chamber isolation and conductor support. They are the weak links in the electrical insulation and mechanical strength of GIS/GIL equipment, and are related to the safe and reliable operation of high-voltage transmission lines. Under AC voltage, the basin-shaped insulator weakens the tangential field strength, reduces the flashover voltage, and ensures the bonding strength between the conductor and epoxy. Unlike the AC, in the DC GIS/GIL, space charged particles drift, diffuse, and accumulate on the surface of the insulator, distorting the initial capacitive electric field. At this time, although the tangential field strength of the basin-shaped insulator is small, its strong normal component attracts a large number of charged particles to accumulate on the surface, which increases the risk of flashover along the surface. The use of low basin insulators or plate insulators can effectively reduce the normal electric field component and reduce charge accumulation, but it cannot meet the requirements of mechanical characteristics at the same time. In this paper, an AC steady-state electric field model, a DC transient electric field model based on space charge transport, and a stress field model during a pressure test are established. Firstly, the characteristics of electric field distribution along the surface of basin insulators under AC and DC voltages are compared and analyzed. The electric charge accumulation and electric field distortion of basin insulators under DC voltage conditions are obtained, and the key structural parameters that affect the charge accumulation under DC voltage are determined. Secondly, the electrical and mechanical characteristics of basin and plate insulators are compared and analyzed. An electrical and mechanical collaborative design scheme of the high-voltage DC GIS/GIL insulator structure is proposed, which provides important theoretical support for the modification of insulator structure.

Review of Key Insulation Technologies of HVDC GIL

Research and Application of UHVAC Gas-Insulated Transmission Line

Insulation Design of Gas Insulated HVDC Transmission Line

Research progress on environmental-friendly insulating gases for HVDC gas-insulated transmission lines

Review of Surface Charge Accumulation on Insulators in DC Gas-Insulated Power Transmission Lines: Measurement and Suppression Measures

Design of a ±320 Kv DC GIL

Research Status and Prospect of Gas-insulated Metal Enclosed Transmission Line

Advanced Dielectrics for Gas-Insulated Transmission Lines [Editorial]

Gas–solid Interface Charge Characterisation Techniques for HVDC GIS/GIL Insulators

Modification of HVDC GIS/GIL Basin Insulators Based on Electrical and Mechanical Collaborative Design

Designing HVDC GIS/GIL spacer to suppress charge accumulation

Insight into Charge-Induced Flashover at the Gas–solid Interface in DC Gas-Insulated Systems

Particle behavior and trap design for ±320 kV gas-insulated power transmission line (GIL)

Study on Key Technology of ±800 Kv UHVDC GIL

Research on Insulation Design of UHV Gas-Insulated Metal-Enclosed Transmission Line

Review of Key Technologies in Modeling and Control of DC Transmission Systems Based on IGCT

Electric Field Simulation of a Voltage Graded Type Insulator for DC GIL

Surface Charging Phenomena on HVDC Spacers for Compressed SF 6 Insulation and Charge Tailoring Strategies

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Study of Charge Accumulation Along the Insulator Surface in the DC GIL