INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER
Xue Zhiliang,Li Feng,Zhu Youqi,Jiang Zhi,Zhou Yonggang,Wu Xuecheng
DOI: https://doi.org/10.1615/atomizspr.2021037284
IF: 1.134
2021-01-01
Atomization and Sprays
Abstract:Fuel slingers have been widely employed in various types of small aero-engines. We built a measurement system of an atomization field on a centrifugal fuel slinger test bench. A suction hood with a perforated plate was used to prevent oil mist spilling and its flow field was simulated by ANSYS software. The droplet size distribution, velocity, and spray cone angle were obtained by a phase Doppler anemometer under different fuel flow rates, gas supply pressure, and rotational speed. Based on numerical simulation, the radial velocity is uniform and the velocity field near the fuel slinger is an order of magnitude lower than the droplet velocity. The trajectory of the spray droplets around the fuel slinger changed little, indicating that its influence on the measured atomization field can be ignored. Furthermore, the results of droplet size distribution are obtained. With increasing rotational speed, the Sauter mean diameter (SMD) of the droplets and spray cone angle decrease, and the atomization field is centralized in an axial direction. As the rotational speed increases from 12,000 rpm to 37,122 rpm, the mean value of SMD shows a 43.8% decrease from 69.72 mu m to 46.87 mu m at Z = 30 mm, and spray cone angle decreases from 42 degrees to 26 degrees. However, the SMD changes little with an increase in fuel flow rate or gas supply pressure. When the distance away from the nozzle outlet increases, SMD and the velocity both increase, but the rate of increase decreases gradually.