Immobilisation of Caesium in Magnesium Phosphate-Based Blends

Yuanzheng Yue,Qian-Mei Zhou,Yun Bai,L Li,Jingke Song,Changkook You,Jueshi Qian,C McCague,Fei Jin,Abir Al‐Tabbaa,H. J. Mo,Man-Jun Deng

2016-01-01

Abstract:Disposal of Caesium (Cs) by incorporating it into host matrices has been proved as a promising concept. Even though Portland cement (PC) based systems can be used to encapsulate low (LLW) or intermediate level waste (ILW), they are not efficient for immobilising Cs due to the very high water-solubility of Cs. Magnesium phosphate cement (MPC), a chemically bonded ceramic consists of struvite families produced by the acid based reactions between dead-burnt magnesium oxide (MgO) and phosphates (e.g., KH2PO4), can be a potential candidate for hosting Cs, since it has been reported that Cs can be incorporated in the Kstruvite structures by substituting potassium (K) to form (K,Cs)-struvite. However, the acid-based reaction to form MPC under ambient temperature between magnesium oxide (MgO) and phosphates (e.g., KH2PO4) is violent and exothermic, which raises concerns about industrial application of MPC in real world. In this work, ground-granulated blast-furnace slag (GGBS) and pulverised fuel ash were used to replace MPC in order to reduce the heat released. The feasibility of MPC, as well as MPC-based blends, i.e. GGBS-MPC or PFAMPC matrices, for immobilising Cs was assessed by their leaching behaviour at the ages of 3d, 7d and 28d. In addition, two typical PC based systems currently used in nuclear waste immobilisation, i.e., pure PC and PC-GGBS (1:9) mixes, were also produced and tested as controls. The results indicated that all the MPC mixes, including pure MPC, GGBS-MPC and PFA-MPC, demonstrated superb capability for immobilising Cs, with the immobilisation rates achieved more than 99.5% at all curing age investigated. Compared to the traditional PC and PC/GGBS mixes, the MPC mixes nearly doubled the Cs immobilisation rate, which is rather encouraging.