Abstract:By combining grad-div stabilization used for improving pressure-robustness and full domain partition used for parallelization, a new parallel finite element method for the steady Navier–Stokes problem with friction boundary conditions is developed and analyzed. Within this parallel procedure, each processor assigned with one subdomain uses a composite grid to calculate a local approximation solution in its own subdomain, making the method simple and easy to carry out on the basis of existing sequential solver excluding a lot of effort in recoding on the top of existing serial software. We rigorously derive the uniform error estimates concerning the fine grid size h , the viscosity and stabilization parameter for the velocity, gradient of velocity and pressure in norms and for the pressure in norm for the standard grad-div stabilized method. On the basis of the derived uniform error estimates and local a priori estimate for grad-div stabilized solution, we further give the uniform error estimates for the local and parallel grad-div stabilized methods. It is shown theoretically and numerically that our present method can reduce the influence of pressure on the error of velocity when the viscosity is small. Specifically, it can yield better approximate velocity than its counterpart excluding grad-div stabilization. The smaller the viscosity coefficient, the higher improvment in accuracy of the approximate velocity. Besides, it can provide approximate solutions for the velocity and pressure with the same basically precision and convergence rate as the ones calculated by the standard grad-div stabilized method with a massive decrease in CPU time.

Parallel Pressure Projection Stabilized Finite Element Algorithms Based on Two-Grid Discretizations for Incompressible Flows

A New Parallel Finite Element Algorithm for the Stationary Navier-Stokes Equations

A Parallel Finite Element Discretization Algorithm Based on Grad-Div Stabilization for the Navier–Stokes Equations

A comparison of three kinds of local and parallel finite element algorithms based on two-grid discretizations for the stationary Navier–Stokes equations

A New Parallel Finite Element Algorithm Based On Two-Grid Discretization For The Generalized Stokes Problem

Development of a Finite Element/discontinuous Galerkin/level Set Approach for the Simulation of Incompressible Two Phase Flow.

Improved parallel finite element methods for the stationary Navier–Stokes problem

A stabilized finite element method based on local polynomial pressure projection for the stationary Navier--Stokes equations

An Efficient Two-Step Algorithm for the Incompressible Flow Problem.

A parallel finite element post-processing algorithm for the damped Stokes equations

Parallel Finite Element Algorithm Based on Full Domain Partition for Stationary Stokes Equations

Local and Parallel Finite Element Algorithms Based on the Partition of Unity for the Stokes Problem

Superconvergence Of Stabilized Low Order Finite Volume Approximation For The Three-Dimensional Stationary Navier-Stokes Equations

Implementation Of The Divergence-Free And Pressure-Oscillation-Free Projection Method For Solving The Incompressible Navier-Stokes Equations On The Collocated Grids

A parallel finite element variational multiscale method based on fully overlapping domain decomposition for incompressible flows

Analysis of a Parallel Grad-Div Stabilized Method for the Navier–Stokes Problem with Friction Boundary Conditions

Parallel Finite Element Algorithms Based on Fully Overlapping Domain Decomposition for Time-dependent Navier-Stokes Equations

A New Stabilized Finite Element Method for the Transient Navier–Stokes Equations

A Low-Communication-overhead Parallel Method for the 3D Incompressible Navier-Stokes Equations

A Characteristic Stabilized Finite Element Method for the Non-Stationary Navier–Stokes Equations

Discontinuous element pressure gradient stabilizations for compressible Navier-Stokes equations based on local projections