Abstract:The propagation of detonation waves in reactive media bounded by an inert, compressible layer is examined via computational simulations in two different geometries, axisymmetric cylinders and two dimensional, planar slabs. For simplicity, an ideal gas equation of state is used with a pressure-dependent reaction rate that results in a stable detonation wave structure. The detonation is initiated as an ideal Chapman-Jouguet (CJ) detonation with a one-dimensional structure, and then allowed to propagate into a finite diameter or thickness layer of explosive surrounded by an inert layer. The yielding confinement of the inert layer results in the detonation wave decaying to a sub-CJ steady state velocity or failing entirely. Simulations are performed with different values of the reaction rate pressure exponent (n = 2 and 3) and different impedance confinement (greater than, less than, and equal to the confinement of the explosive). The velocity decrement and critical dimension (critical diameter or thickness) are determined, and a 2:1 scaling between the cylinder diameter and slab thickness results is confirmed, in good agreement with curvature-based models of detonation propagation. The measured shock front curvature and detonation velocity relation agrees with the classic model of Wood and Kirkwood. The computational simulations are compared to a simple, analytic model that treats the interaction of the confinement with the detonation products via Newtonian theory and a model that assumes a continuous variation in shock front curvature with the shock angle at the interface with the confinement matching the angle determined by shock polar analysis. The Newtonian model works very well for the case of high impedance confinement, while the shock front curvature model agrees with the simulations for the case of low impedance confinement.

Probe Cylinder Test Method and Calibration of JWL Equation of State of Detonation Products for TNT Explosive

Determination of Parameters of JWL Equation of State for Unreacted Explosives Based on BP?GA Algorithm

Automatic Optimization of JWL‐Miller parameters of HMX‐based aluminized explosive based on genetic algorithm

Comparative study on the equation of state of detonation products

Equation of State of Detonation Products for PETN Explosive

Numerical Investigation on Effects of Ignition Energy on Two-phase Detonation Wave Formation

Numerical Study of PBX 9501 Explosive Combustion Process in Confined Space

Near-MHz temperature and H2O measurements in post-detonation fireballs of 25 g hemispherical explosives using scanned-wavelength-modulation spectroscopy

Namerical Simulation on Factors Affecting Ignition Characteristics of A New Engine

Analysis of Blast Wave Propgation Inside Tunnels

TNT equivalency method in confined space based on steel plate deformation

Experimental system of constant volume combustion bomb and measurement of C7 fuels flame speeds

Measurement of Dynamic Fracture Parameters of Explosive Cylindrical Shells

Combustion Characteristic Parameter Testing and Caculating of Single-Base Propellant

Calibration and uncertainty quantification for Davis Equation of State models for the High Explosive PBX 9501 products

Numerical and experimental study on the response characteristics of warhead in the fast cook-off process

Seismic Waves Comparative Analysis of Thermobaric Explosive and TNT Explosive in Shallow Underground Chemical Explosion

Geometric Scaling for a Detonation Wave Governed by a Pressure-Dependent Reaction Rate and Yielding Confinement

Measurement of Dynamic Fracture Parameters in the Expansion Process at High Strain Rate

A complete equation of state for non-ideal condensed phase explosives

Experimental study on initiation and propagation behavior of propane/oxygen/nitrogen detonation wave