Abstract:Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and near future in which a combination of clean combustion and high thermodynamic efficiency is considered to be necessary to satisfy demands for CO2 emissions mitigation.From the 1970s on, attention has increasingly turned towards emission control technologies for the reduction of oxides of nitrogen and sulfur, the so-called acid rain precursors. By a better understanding of the NOx formation and destruction mechanisms in flames, it has become possible to reduce significantly their emissions via combustion process modifications, e.g. by maintaining sequentially fuel-rich and fuel-lean combustion zones in a burner flame or in the combustion chamber, or by injecting a hydrocarbon rich fuel into the NOx bearing combustion products of a primary fuel such as coal.Sulfur capture in the combustion process proved to be more difficult because calcium sulfate, the reaction product of SO2 and additive lime, is unstable at the high temperature of pulverized coal combustion. It is possible to retain sulfur by the application of fluidized combustion in which coal burns at much reduced combustion temperatures. Fluidized bed combustion is, however, primarily intended for the utilization of low grade, low volatile coals in smaller capacity units, which leaves the task of sulfur capture for the majority of coal fired boilers to flue gas desulfurization.During the last decade, several new factors emerged which influenced the development of combustion for power generation. CO2 emission control is gaining increasing acceptance as a result of the international greenhouse gas debate. This is adding the task of raising the thermodynamic efficiency of the power generating cycle to the existing demands for reduced pollutant emission. Reassessments of the long-term availability of natural gas, and the development of low NOx and highly efficient gas turbine–steam combined cycles made this mode of power generation greatly attractive also for base load operation.However, the real prize and challenge of power generation R&D remains to be the development of highly efficient and clean coal-fired systems. The most promising of these include pulverized coal combustion in a supercritical steam boiler, pressurized fluid bed combustion without or with topping combustion, air heater gas turbine-steam combined cycle, and integrated gasification combined cycle. In the longer term, catalytic combustion in gas turbines and coal gasification-fuel cell systems hold out promise for even lower emissions and higher thermodynamic cycle efficiency. The present state of these advanced power-generating cycles together with their potential for application in the near future is discussed, and the key role of combustion science and technology as a guide in their continuing development highlighted.

Biomass and Biogas Flameless Combustion

Measurements and Modelling of Oxy-Fuel Coal Combustion

Research On An Approach To High Temperature Flameless Combustion Technology Of Biomass

An approach to high temperature flameless combustion technology of biomass

Efficient Combustion of Low Calorific Industrial Gases: Opportunities and Challenges

Overview of recent advances in thermo-chemical conversion of biomass

Research on the three different kinds of technologies to achieve flameless combustion and their applications

Combustion Simulation with Particular Reference to Green Aviation

Gas Oxy Combustion and Conversion Technologies for Low Carbon Energy: Fundamentals, Modeling and Reactors

Oxyfuel Cofiring Characteristics of Biomass with Ultralow Volatile Carbon-Based Fuels

Recent Progress in Research on Efficient Low Polluting Combustion and Gasification Technology

Flame stabilization and emission characteristics of ammonia combustion in lab-scale gas turbine combustors: Recent progress and prospects

Research development of pulverized coal flameless combustion technology and low NOx emission

Pollutant Emissions during Oxy-Fuel Combustion of Biomass in a Bench Scale CFB Combustor

Cutting-edge biomass gasification technologies for renewable energy generation and achieving net zero emissions

Combustion technology developments in power generation in response to environmental challenges

An Overview Of Advances In Biomass Gasification

Study Of Biomass Gasification And Combustion

Numerical investigation of biomass and liquefied natural gas driven oxy-fuel combustion power system

Reduced Pollutant Emissions and Slagging Rate of Biomass Pellet Combustion by Optimizing the Multilayer Distribution of Secondary Air

Low-Temperature-Solid Combustion Technology of Biomass for Pollution Reduction: Potentials and Necessary Fundamentals