A Model for Low-Frequency, Anisotropic Wind Fluctuations and Coherences in the Marine Atmosphere

Syed, Abdul Haseeb,Mann, Jakob

DOI: https://doi.org/10.1007/s10546-023-00850-w

2024-01-12

Boundary-Layer Meteorology

Abstract:To assess dynamic loads, large offshore wind turbines need detailed and reliable statistical information on the inflow turbulence. We present a model that includes low frequencies down to hr using the observed in that range. The presented model contains a parameter representing the anisotropy of the two-dimensional, incompressible turbulence, and it assumes the low-frequency fluctuations to be homogeneous in the vertical direction. Combined with a three-dimensional model for the smaller scales, the model can predict correlations between different points. We have validated the model against two offshore wind data sets: a nacelle-mounted, forward-looking Doppler lidar with four beams at the Hywind Scotland offshore wind farm and sonic anemometer measurements at the FINO1 research platform in the North Sea. One-point auto spectra and two-point cross spectra were calculated after splitting the data into different atmospheric stability classes. The relative strength of the 2D low-frequency fluctuations to the 3D fluctuations was higher under stable conditions. The combined 2D+3D model was able to fit the measured spectra with good accuracy and could then predict the two-point cross spectra, co-coherences, and phase angles between wind fluctuations at different lateral and vertical separations. Good agreement was found between the measured and predicted values, albeit with exceptions. The model can generate stochastic wind fields for investigating wake meandering in wind farms or dynamic loads on floating wind turbines.

meteorology & atmospheric sciences

What problem does this paper attempt to address?

The paper attempts to address the issue that large offshore wind turbines in the marine atmospheric boundary layer require detailed and reliable turbulence statistics to assess dynamic loads. Specifically, the paper focuses on how to model and predict low-frequency (down to about 1 hour^-1) anisotropic wind speed fluctuations and their correlations between different points. Traditional turbulence models mainly target high-frequency fluctuations and neutral atmospheric conditions, and these models are often not accurate enough in predicting low-frequency fluctuations, especially under stable atmospheric conditions. Therefore, this paper proposes a new model aimed at filling this gap to more accurately describe low-frequency, anisotropic wind speed fluctuations, thereby better assessing the dynamic loads of large offshore wind turbines.

The paper introduces a parameter describing the anisotropy of two-dimensional incompressible turbulence and assumes that low-frequency fluctuations are uniform in the vertical direction, combining it with a three-dimensional model to predict correlations between different points. The model is validated on two offshore wind datasets, including forward-looking Doppler lidar data from a 6 MW floating wind turbine installed at the Hywind Scotland offshore wind farm, and acoustic anemometer measurement data from the FINO1 research platform in the southern North Sea. By categorizing the data into different atmospheric stability classes, the one-point autospectrum and two-point cross-spectrum were calculated and compared with the model predictions. The results show that the model can fit the measured spectra well and predict the two-point cross-spectrum, coherence, and phase angle under different lateral and vertical separations.