Abstract:A modified polymerizable complex (PC) method for the preparation of the relaxor ferroelectric 0.65Pb(Mg1/3Nb2/3)O-3-0.35PbTiO(3) (PMN-PT) ceramics has been developed using a novel water-soluble Nb precursor. The effects of Pb content and sintering temperature on the structure, morphology, composition, and electrical properties of PMN-PT powders and ceramics were investigated systematically. It was found that the modified PC method could effectively reduce the initial crystallization temperature of the perovskite phase to 500 degrees C. For PMN-PT samples with 15% excess Pb content sintered at 600 degrees C for 2 h, the 87% perovskite phase can be achieved, which is much higher than that in conventional solid-state reactions and other solution-based methods at the same temperature. On further increasing the sintering temperature to 1100 degrees C, the perovskite phase content basically remains constant. This is attributed to the Pb-deficient pyrochlore phase formation. On increasing the sintering temperature to 1250 degrees C, the dielectric constant and remnant polarization of PMN-PT ceramics significantly improved due to the larger grain sizes, enhanced density, and the decreasing pyrochlore phase. PMN-PT ceramics with a 98.5% content of the perovskite phase have been fabricated at 1250 degrees C. It displays typical ferroelectric relaxor characteristics with a remnant polarization of 18 mu C/cm(2), a coercive field of 9.6 kV/cm, a piezoelectric coefficient of d(33) = 360 pC/N, and room-temperature and maximum dielectric constants of 3600 and 10 500 at 1 kHz, respectively.

X7R Type Lead Complex Perovskite Ferroelectric Ceramics with High Dielectric Constant

Ferroelectric Phase Transition and Electrical Properties of High-Tc PMN-PH-PT Ceramics Prepared by Partial Oxalate Route

Composition Design of PMN-PH-PT Piezoelectric Ceramics for High-Temperature Actuator Applications

Pb(Mg 1/3 Nb 2/3 )O 3 -Pbtio 3 -Batio 3 Complex Perovskite Ferroelectric Ceramics with High Dielectric Constant and Low Firing Temperature

A new (1 - X)Pb(Lu1/2Nb1/2)O3-xPbTiO 3 binary ferroelectric crystal system with high Curie temperature

A New Type of Dielectric Composite with X7r Characteristic and High Dielectric Constant

Preparation and Study of Dielectric Properties for X7R Biphasic Ceramics

Investigation on Microscopic Mechanisms of High-Curie Temperature PMN-PH-PT Piezoelectric Ceramics

New dielectric-temperature characteristics of BT and PMN cofired ceramics

Preparation, Structure, and Electric Properties of the Pb(Zn1/3Nb2/3)O3–Pb(Yb1/2Nb1/2)O3–PbTiO3 Ternary Ferroelectric System Ceramics Near the Morphotropic Phase Boundary

Study On Structure And Properties Of X7r Ceramics Based On Batio3 With High Dielectric Constants

Synthesis, Structure, and Dielectric Properties of a New Binary Antiferroelectric Solid Solution: (1−X)pb(mg1/2w1/2)o3–xpbhfo3

Study on Dielectric-Properties of Pmn-Pzn-Pt Ferroelectric Relaxor Ceramics

Preparation and Characterization of Relaxor Ferroelectric 0.65pb (Mg1/3nb2/3)o-3-0.35pbtio(3) by A Polymerizable Complex Method

Study of the Structure and Dielectric Relaxation Behavior of Pb(Mg1/3Nb2/3)O3–PbTiO3 Ferroelectric Ceramics

Electrical Properties of (1–X)(0.8pmn-0.2Pnn)-xpt Ceramics Near the Morphotropic Phase Boundary

Study of the structure and dielectric relaxation behavior of Pb(Mg 1/3 Nb 2/3 )O 3 –PbTiO 3 ferroelectric ceramics

Enhanced dielectric and ferroelectric properties in lead magnesium niobate-lead titanate ferroelectrics solid solutions by controlling the sintering protocols

Structure and Dielectric Behavior of Pb(Mg1/3Nb2/3)O3–Pb(Ni1/3Nb2/3)O3–Pb(Zn1/3Nb2/3)O3–PbTiO3 Ferroelectric Ceramics Near the Morphotropic Phase Boundary

Temperature-Stable Pb(Zn1/3nb2/3)O-3-Based Ceramics Prepared by Mixed Sintering Method