An experimental investigation of the effect of alkane fuel structure on reactivity demonstrated through the hexane isomers
C. Banyon,K. Zhang,H. J. Curran
2015-01-01
Abstract:The current work attempts to provide insight into, and improve the fidelity of chemical kinetic models for transportation relevant branched alkanes, which is achieved through a study of the structural isomers of hexane; nhexane, 2-methylpentane, 3-methylpentane, 2,2-dimethylbutane and 2,3-dimethylbutane. The main objectives of this study are to extend the NUIG sub-mechanism to C6 alkanes, as well as to expand the available species palette for surrogate fuels. To facilitate this study an experimental approach is taken here, while a complementary kinetic modeling study is currently underway. Ignition delay data have been obtained for the five hexane isomers in a highpressure shock tube (HPST) and in a rapid compression machine (RCM) at φ = 1, p = 15 bar and ΧO2 = 21% in the temperature range 600–1300 K. At low temperatures (i.e. below 1000 K) the comparative reactivity of the isomers correlates with research octane number, while at high temperatures (i.e. above 1000 K) differences in the ignition delay times between the isomers becomes small. The ignition delay data collected in this study serve as validation targets for the newly developed C6 mechanism, where good agreement is observed. Future work is planned to use the validated hexane mechanisms to investigate the performance of fourand five-component surrogate mixtures for diesel and gasoline fuels blended with several of the hexane isomers investigated in this study to potentially improve surrogate performance. Corresponding author: henry.curran@nuigalway.ie Proceedings of the European Combustion Meeting 2015 Introduction Advanced combustion strategies that rely on lowtemperature, lean-charge, kinetically controlled schemes (e.g. HCCI, RCCI, PPC, etc.) have demonstrated significant progress toward clean, high-efficiency transportation engines [1]. Reliable kinetic models for fuel decomposition and oxidation chemistry facilitate the design of these advanced combustion engines as a predictive tool for assigning ignition timing, rate of heat release, engine-out emissions, etc. While reliable chemical kinetic models for straight-chain alkanes have matured for species relevant to transportation fuels, less work has been conducted on branched alkanes, which can constitute a large fraction of petroleum-derived fuels and their surrogates. Work on branched alkanes has been conducted but very few studies have investigated the influence of alkane isomeric structure on fuel reactivity in the lowto intermediatetemperature regime. Gersen et al. [2] and Healy et al. [3,4] independently studied the two isomers of butane, nand iso-butane, in a rapid compression machine (RCM) over a wide range of conditions. iso-Butane was found to be less reactive than n-butane, and both fuels showed negative temperature coefficient (NTC) behavior. The three pentane isomers were investigated in an RCM by Ribaucour et. al. [5], and more recently by Bugler et al. [6]. It was found that n-pentane is the most reactive, followed by neo-pentane, with isopentane being the least reactive. The hexane isomers were recently studied by Wang et al. [7] in a jet-stirred reactor (JSR) over the lowand intermediatetemperature range. Species concentrations were measured by both gas chromatography and synchrotron vacuum ultraviolet photoionization mass spectrometry. Cyclic ether concentrations were measured for all of the isomers, which are an important intermediate species in the NTC regime. Ignition delay times were measured in an RCM for the nine heptane isomers by Silke et al. [8]. It was found that fuel reactivity correlates with the amount of branching in the fuel, where the more branched isomers were less reactive. Fuel reactivity in the NTC region was also found to correlate with research octane number (RON). The current work attempts to provide insights into, and improve the fidelity of chemical kinetic models for transportation relevant branched alkanes, which is achieved through a study of the structural isomers of hexane; n-hexane (nH), 2-methylpentane (2MP), 3methylpentane (3MP), 2,2-dimethylbutane (22DMB) Figure 1 – Chemical structures of the five hexane isomers.