Active Broadband Absorber Based on Phase-Change Materials Optimized via Evolutionary Algorithm
Jing Ma,Yonghong Tian,Jingyi Cheng,Shubo Cheng,Bin Tang,Jing Chen,Yougen Yi,Pinghui Wu,Zao Yi,Tangyou Sun
DOI: https://doi.org/10.3390/coatings13091604
IF: 3.236
2023-09-15
Coatings
Abstract:This article proposes a temperature-controlled absorber based on VO2, which consists of five layers: a disk-shaped VO2 layer array, a dielectric layer, a circular hole VO2 array, a SiO2 layer, and a gold substrate from top to bottom. We optimized the thickness of the other four layers of the absorber, except for the gold layer, using PSO. After ten iterations, we determined that the optimal parameters for the top-to-bottom four-layer thicknesses were 0.183 μm, 0.452 μm, 0.557 μm and 1.994 μm. At this point, our absorber reached the optimal absorption parameters, and we plotted the absorption spectrum under these conditions. We found that the absorption rate at 29.1–47.2 THz was higher than 90%, and the absorption bandwidth was as high as 18.1 THZ. This frequency band covers most of the atmospheric window area (23–37.5 THz), so it will have good practicality. At 30.8 THz and 43.12 THz, there were perfect absorption peaks with absorption rates of 99.99% and 99.99%, respectively. We explained the cause of absorption from the perspective of electric field, and then we studied the change in the absorption curve of the absorber when the temperature of VO2 changed, and we can directly observe the changes in the electric field to explain this. Finally, we can tune the bandwidth and absorption rate of the absorber by changing the structure of the VO2 pattern. After comparing with other absorbers developed in recent years, our absorber still has good competitiveness, and we believe that our solution is expected to have outstanding performance in fields such as photothermal conversion and thermal stealth in the future.
materials science, multidisciplinary,physics, applied, coatings & films