Abstract:As with any heat exchanger, the function of a nuclear steam generator is compromised by operational changes that increase the resistance to heat transfer between the primary and secondary fluids, lowering the efficiency and leading to thermal performance degradation. This type of performance degradation, the underlying causes, industry experience, and plant operational consequences had been discussed by ERRI and DEI reference documentations. After 6–10 years operation the steam pressure degradation of most plants occurred. The steam pressure of steam generator (SG) in Ningde nuclear power plant (NPP) decreased after the unit was in commercial operation. It decreased by 1 bar in first fuel cycle, and it was down by 0.5 bar at the second and third cycle. And the same type of nuclear power plant in France had no similar status. It was also different with the situations of American units. In this paper it concludes that the main cause of steam pressure loss is the sludge or fouling which accumulated at tubes and supporting plates at the second loop. The eddy current imaging and video inspection results showed that the sludge or deposit were found at the cold side tubes nearby the tube supporting plate one, the sludge amount at hot side tubes was smaller than the cold tubes. In general, there were no deposit signals at the upper tube bundle. And the total amount of sludge on SG tubes was fewer, which was possibly contradiction with the fouling factor. The bundle flushes equipment have been applied at Ningde NPP unit 1, the sludge amount was five times larger than the normal tube sheet flush. This special bundle flush applications reduce the sludge in the SGs, avoid the corrosion of heat transfer tubes and ensure the SGs safety. It is a pity that the SG thermal performance was not recovered quickly after this special flush. The sludge nearby the TSP1 was not the main cause of steam pressure loss. At present, the project team is studying polyacrylic acid (PAA) and chemical cleaning to expand the scope of washing and cleaning effect, and further recover the thermal performance of steam generator.

Study on the Influence of Power Reduction Process on the Leakage Rate of Steam Generator

Experimental Study on Leak Flow Rate Characteristics of High Pressure Subcooled Water Through Axial and Circumferential Microcracks of Steam Generator Tubes under High Back Pressure Conditions

Experimental Investigations on Leak Flow Rate Characteristics of Water Through Axial Artificial Microcracks of Steam Generator Tubes under Back Pressure Conditions

Numerical Simulation of Micro-Crack Leakage on Steam Generator Heat Transfer Tube

The Analysis of Severe Accident Induced Steam Generator Tube Rupture and Lerf Risk

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Determination of the Critical Crack Length for Steam Generator Tubing Based on Fracture-Mechanics-based Method

Three-dimensional study on the hydraulic characteristics under the steam generator (SG) tube plugging operations for AP1000

The analysis of severe accident induced steam generator tube rupture and mitigation measure

A Cumulative Damage Model for Tubes in Nuclear Power Plants Subject to Continuous Degradation and Multi-Effect Shocks under Dynamic Environments

Leakage of water-cooled wall tube in subcritical boiler

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Experimental Study On The Steam-Water Co-Current Flow Friction Multiplier Of The Ap1000 Surge Line

Progress in Studying the Fretting Wear/corrosion of Nuclear Steam Generator Tubes

Analysis of Frequent Tube Burst of High Temperature Reheater in 600 MW Unit

Transient Stress Analysis of High Pressure Heater During Feedwater Bypass Regulations

Life prediction of steam generator tubing due to stress corrosion crack using Monte Carlo Simulation

Failure Analysis on Abnormal Leakage Between Tubes and Tubesheet of Spiral-Wound Heat Exchanger for Nuclear Power Plant

Numerical Investigation of Postulated Steam Generator Tube Rupture Accident in a Lead-Cooled Fast Reactor

The Research of Steam Generator Thermal Performance Degradation in Nuclear Power Plant

Failure Estimation Methods for Steam Generator Tubes with Wall-Thinning or Crack