Abstract:This paper presents a low power reconfigurable IC for wearable health devices that perform bio-impedance (BioZ) spectroscopy, respiration, and ECG signals measurement. The IC consists of a broadband excitation current source (I-DAC) and a power efficient readout circuit (RO). Both are highly scalable to mitigate the tradeoff among noise, dynamic range, speed, power, and safe current limits. On circuit level, the I-DAC supports two broadband excitation modes based on maximum length sequence (MLS), a flexible selection of frequency points, bandwidth, and current magnitude. The RO employs a low noise instrumentation amplifier and a reconfigurable 8-to-12 bit ADC for flexible sensitivity, dynamic range and speed with an automatic scaling of the power consumption. On system level, calibration of the entire circuit chain, oversampling and MLS averaging further improve the bandwidth, accuracy and sensitivity of BioZ spectroscopy beyond the intrinsic circuit performance. As a result, the BioZ sensor IC achieves 2 $\text{m}\Omega $ sensitivity within 3.3 $\text{m}\Omega $ – $100~\Omega $ range and $0.6~\Omega $ sensitivity within $3.3~\Omega $ –100 $\text{k}\Omega $ range. The BioZ spectroscopy spans up to 125 kHz while consuming $155~\mu \text{W}$ . Furthermore, this IC can measure respiration and ECG simultaneously at a lower sampling rate of 20 kS/s while consuming $31~\mu \text{W}$ . Compared to prior art, to the best of our knowledge, this IC is the only work that can measure BioZ and ECG simultaneously with a single readout channel while consuming the lowest power and offering the highest flexibility in performance, application range, and power consumption.

A review on direct digital conversion for biomedical signal acquisition ICs

A Review on Direct Digital Conversion Techniques for Biomedical Signal Acquisition

Power Efficiency Comparison of Event-Driven and Fixed-Rate Signal Conversion and Compression for Biomedical Applications

A 140 Db-Dr Light-to-Digital Converter Using Current-Domain Hybrid Zoom for Baseline Cancellation and Interference Compensation

A 30- $\mu$ W 94.7-Db SNDR Noise-Shaping Current-Mode Direct-to-Digital Converter Using Triple-Slope Quantizer for PPG/NIRS Readout

Brief Architectural Survey of Biopotential Recording Front-Ends since the 1970s

A 107.6 dB-DR Three-Step Incremental ADC for Motion-Tolerate Biopotential Signals Recording

A 108db DR Hybrid-CTDT Direct-Digitalization ΔΣ-ΣM Front-End with 720mvpp Input Range and >300mv Offset Removal for Wearable Bio-Signal Recording.

A 1.8V 16μA 136.5dB DR PPG/NIRS Recording IC using Noise Shaping Triple Slope Light to Digital Converter

Experimental characterization of detecting and processing method for ECG applications

A 44μw 140Db-Dr Hybrid Light-to-Digital Converter with Current-Tracking Dynamic Zoom and Power-Scaling OTA

Paper-Recorded ECG Digitization Method with Automatic Reference Voltage Selection for Telemonitoring and Diagnosis

A/D Converter Architectures for Energy-Efficient Vision Processor

Integrated circuits and electrode interfaces for noninvasive physiological monitoring

An Energy-Efficient and Reconfigurable Sensor IC for Bio-Impedance Spectroscopy and ECG Recording

Deep Conviction Systems for Biomedical Applications Using Intuiting Procedures With Cross Point Approach

Signal Processing System-on-chip Design for Biomedical Applications.

High-Input-Impedance Amplifiers Design for Dry-Electrode Biopotential Acquisition: A Review

A 119dB Dynamic Range Charge Counting Light-to-Digital Converter For Wearable PPG/NIRS Monitoring Applications

A Review of PPG/NIRS Acquisition ASIC and System.

A Review on Recent Development of Input Impedance Boosting for Bio-Potential Amplifiers