Abstract:In a DC distribution network, the solid-state transformer (SST) and energy storage systems require an isolated bidirectional DC–DC converter (IBDC). Among the many IBDCs, the dual active bridge (DAB) converter has been widely studied due to its advantages in terms of high power density and high efficiency. The traditional control strategy for DAB is phase shift control. However, when the primary and secondary side voltages do not match, the soft-switching characteristic and increasing current in the phase shift control affect the application of DAB in scenarios involving input and output voltage changes. To improve the above-mentioned defects, a novel asymmetric duty modulation (ADM) control is proposed in this paper. Among the various multi-variable ADM controls, the two-variable ADM control is simple, but its current is higher under light loads. To improve this defect, this paper introduces trapezoidal modulation (TZM) control proposed for phase shift control into ADM to form a similar TZM (STZM) control corresponding to TZM control. This paper first expounds the basic principle of STZM control. On this basis, its basic characteristics are researched. With current stress as the optimization goal, an optimal STZM (OSTZM) control scheme with minimum current stress is proposed, and the effectiveness of the theoretical analysis is verified on the experimental bench. The result shows that STZM control can improve efficiency under light loads by reducing the current and ensuring full ZVS.

Research on Multiple Duty Modulation Scheme in Dual-Active-Bridge-Based Energy Storage System

Dual-Side Asymmetric Duty Modulation Based on Accurate Soft-Switching Characteristics Modeling for DAB-Based DC Microgrid

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

A Full-Power-Range Optimization Scheme Under Double-Side Asymmetrical Phase-Shift Modulation in DAB-Based Distributed Energy Storage System

Research on Asymmetric Modulation Scheme with Minimum RMS Inductor Current Stress

Hybrid Duty Modulation for Dual Active Bridge Converter to Minimize RMS Current and Extend Soft-Switching Range Using the Frequency Domain Analysis

Modulation of 2/3-Level Dual-Active-Bridge DC-DC Converters for Soft-Switching and Minimum Current Stress.

An Optimal Primary-Side Duty Modulation Scheme with Minimum Peak-to-Peak Current Stress for DAB-Based EV Applications

Multi-Objective Optimization Method Based on Double-Side Asymmetrical Modulation Scheme for DAB-Based DC-DC Converter

A Collaborative Modulation Method of Dual-Side Backflow Power Optimization and Zero-Voltage Switching for Dual Active Bridge

Novel asymmetric duty modulation for DAB converters to improve light load efficiency

Fundamental Duty Modulation of Dual-Active-Bridge Converter for Wide-Range Operation

Optimal Dual-Side Asymmetric Modulation Strategy for Dual Active Bridge Converter to Improve Efficiency over a Wide Voltage Range

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

A RMS Current Minimization Method for Three-Level ANPC-DAB-Based Distributed Energy Storage System With Full Operation ZVS

Research on Optimum Extended Phase-Shift Control with Minimum Peak-to-peak Current of DAB Converter Applied to Small DC Power Grid

Composite Duty Modulation of Dual Active Bridge Converters to Minimize Output Voltage Ripples and Inductor RMS Currents

Optimal Dead-Time Design Method Based on Single-Side Asymmetrical Duty Modulation for DAB-Based Energy Storage System

On Soft Switching Characteristics of Dual Active Bridge Converters Applied in Energy Storage Systems

A Novel Asymmetric Duty Modulation Control of Dual-Active-Bridge for LVDC Applications

Overview of Multi-Degree-of-Freedom Modulation Techniques for Dual Active Bridge Converter