Numerical Investigations on Aero-Engine Icing Characteristics at Mixed Phase Conditions
Haifeng Qi,Shinan Chang,Yinglin Yang,Peiping Chang
DOI: https://doi.org/10.1016/j.applthermaleng.2023.122044
IF: 6.4
2024-01-01
Applied Thermal Engineering
Abstract:Ice crystal/mixed phase icing in aero-engine will cause engine surge, stalling, thrust reduction, and even stop in extreme cases, which seriously endangers flight safety. In this paper, the characteristics of mixed phase ice accretion in aero-engines are numerically studied. The air flow field model, mixed phase trajectory model, impact model, sticking model and ice accretion model are established. Meanwhile, the sensitivity parameters of ice accretion, such as flight speed, icing time, melting rate (LWC/TWC), and relative humidity (RH), were investigated in detail. The results show that the ice thickness of nacelle surface and nosecone surface increases with the increase of flight speed. With the increase of fan span, the icing thickness of the fan surface increases significantly. The icing of the fan is mainly concentrated on the pressure side of the fan, while the suction side of the fan only has a small amount of icing in the leading edge. In the early stage of icing, the icing thickness of nacelle increases rapidly, and with the increase of icing time, the icing thickness increases, but the icing growth rate becomes slower. With the increase of the melting rate, the ice thickness of the nacelle, the nosecone and the fan pressure side surface increased significantly. When the fan span is 90 % and the melting rate is 0.05, 0.15, and 0.25, the maximum icing amount on the fan surface is 1.56, 3.85, and 5.71 mm, respectively. When the RH is high, there is more ice accumulation on the nacelle surface. At RH is 80 %, the ice thickness at the nosecone tip reaches 5.48 mm. Finally, when using the hot air deicing method, the hot air flow needs to be reasonably distributed according to the amount of icing, and the parts with less icing can appropriately reduce the distribution of hot air for rational use of energy and energy conservation.