Abstract:Some polymers can be made both piezo- and pyroelectric by suitable application of a large electric field. This effect is true piezo- and pyroelectricity rather than electrostriction, conduction, electromechanical effects, or the motion of conductors in the field of space charges. Two distinct types of polymers can be piezoelectric. Amorphous polymers are piezo- and pyroelectric by virtue of a nonequilibium but kinetically stable net dipole orientation in the amorphous phase of the polymer. The semicrystalline polymers are piezoelectric due to alignment of polar, ferroelectric crystals dispersed in the amorphous phase. In both types of polymers, magnitudes of the piezo- and pyroelectric effects are in accord with the expected temperature and pressure dependence of the dipole model. Polarization changes primarily because of dimensional changes of the sample. Space charges embedded in the polymer normally will not produce large piezoelectric and pyroelectric currents. Those embedded near the crystalliquid interfaces tend to reduce the piezo- and pyroelectricity. Improved orientation of dipoles and reduction of ionic impurities should increase py and dp for PVDF by a factor of two above typical values presently reported. The sensitivity of amorphous and semicrystalline polymers is limited mainly by dipole moment per unit volume and breakdown strength.Some of the models presented here were developed along with the writing and were used as a framework for the presentation in order to make the chapter more coherent. It is hoped that these ideas, some largely untested, will provide direction and stimulation for further work in this field.

Preliminary Measurement Research on Piezo-Stimulated Currents of Polymers

Thermally Stimulated Current Study of Polyimide Film at High Pressures

Slow Current Induced by Partial Discharge in Kapton, Epoxy and PET

Investigation of Wide-Range Trap Energy Spectra of Typical Aerospace Polymer Dielectric Materials by Using Photo-Stimulated Discharge Method

Thermally Stimulated Current of Polyimide Nano-composite

The Elastic Properties and Piezochromism of Polyimide Films under High Pressure

Simultaneous Measurement and Application of Space Charge and Relaxation Current for Solid Dielectric

Method to Determine the Trapping Level of a Polymeric Material from Thermally Stimulated Discharge Current Measurements

Pressure-Dependent Relaxation Dynamics of Excitons in Conjugated Polymer Film

Space Charge Distribution Analysis in Polyethylene under High Static Pressure

A Method for Quantitatively Separating the Piezoelectric Component from the as-received "Piezoelectric" Signal

TSC measurement in polymer insulation characteristic analysis

Study On The Detrapping Of Charge Carriers In Polythylene Films

An Improved Pulsed Electro-acoustic Setup For Space Charge Measurement at High Temperatures

Comparison Between Thermally Stimulated Discharge Method and Photo-stimulated Discharge Method for Measuring Space Charge Traps Energy

The Observation of Photo-Stimulated Discharge of Typical Polymers by OPO Laser

Piezo- and pyroelectric properties

Frequency and Temperature-Dependent Space Charge Characteristics of a Solid Polymer under Unipolar Electrical Stresses of Different Waveforms

Development of space charge direct measurement device for polymer insulation based on PEA

Study on Deep Trap States in Polymers by Photo-Stimulated Discharge Based on the Opo Laser