Abstract:Abstract The mixing of fuel and air in the combustion chamber of an IC engine is crucial to emissions formation. Therefore, developing effective diagnostic techniques for measuring mixing is critical for progressing IC engines. Existing methodologies for the optical measurement of air-fuel mixing, including Rayleigh scattering and Laser Induced Fluorescence (LIF), have demonstrated various diagnostic-implementation challenges, high uncertainties under engine-relevant environments, and strong interferences from the liquid spray which prevents their use in near-spray measurements. This work presents the use of an alternative approach based on a laser-absorption/scattering technique called Ultraviolet-Visible Diffuse Back-Illumination (UV-Vis DBI) to quantify local equivalence ratio in a vaporizing diesel spray. Ultraviolet and visible light are generated using a ND:YAG pumped frequency-doubled tunable dye laser operating at 9.9 kHz. The simultaneous UV-Visible illumination is used to back-illuminate a vaporizing diesel spray, and the resulting extinction of each signal is recorded by a pair of high-speed cameras. Using an aromatic tracer (naphthalene, BP = 218 °C) in a base fuel of dodecane (BP = 215–217 °C), the UV illumination (280 nm) is absorbed along the illumination path through the spray, yielding a projected image of line-of-sight optical depth that is proportional to the path-average fuel vapor concentration in the vapor region of the spray. The visible illumination is chosen at a non-absorbing wavelength (560 nm), such that the light extinction is only due to liquid scattering, yielding a projected image of the liquid spray. A key advantage of the method is that the absorption coefficient of the selected tracer is relatively independent of temperature and pressure for 280-nm illumination, reducing measurement uncertainties at engine-relevant conditions. Measurements are also achievable in near-spray vapor regions since there is no mie-scattering interference from the liquid spray. The diagnostic is applied to measure the fuel-air mixing field of a diesel spray produced by a Bosch CRI3-20 ks1.5 single-orifice injector (90 μm diameter) similar to ECN Spray A. Measurements are conducted in a non-reacting high-pressure and temperature nitrogen environment using a constant-flow, optically-accessible spray chamber operating at 60 bar and 900 K. The results are evaluated against existing ECN mixing measurements based on Rayleigh scattering. The diagnostic yields centerline and radial mixture fraction measurements that match the ECN Rayleigh measurements within uncertainty bounds.

A Combined Optical Diagnostic Based on Ultraviolet Absorption and Planar Laser-Induced Fluorescence for Quantification of Vapor Concentration Distributions in Fuel Sprays

Quantitative Measurement of Binary-Component Fuel Vapor Distributions Via Laser Absorption and Scattering Imaging

A three-color absorption/scattering imaging technique for simultaneous measurements on distributions of temperature and fuel concentration in a spray

VAPOR DISTRIBUTION MEASUREMENT OF HIGHER AND LOWER VOLATILE COMPONENTS IN AN EVAPORATING FUEL SPRAY VIA LASER ABSORPTION SCATTERING (LAS) TECHNIQUE

Co-evaporative multi-component fuel design for in-cylinder PLIF measurement and application in gasoline direct injection research

K-1920 Simultaneous Measurement of Vapor and Liquid Phase Concentration Distributions in a D.I. Diesel Spray by Laser Absorption Scattering Technique

A Multi-Wavelength Extinction Imaging Diagnostic for Quantifying Diesel Spray Mixing at Engine-Relevant Conditions

Measurement of Vapor/Liquid Distributions in A Binary-Component Fuel Spray Using Laser Imaging of Droplet Scattering and Vapor Absorption

Optimizing Precision and Accuracy of Quantitative PLIF of Acetone as a Tracer for Hydrogen Fuel

An Optical Diagnostic Technique Based on Ultraviolet Absorption and Schlieren for Components Stratification in a Binary-Component Fuel–air Mixture

Quantitative Imaging of Temperature and OH Concentration From Single Wavelength Planar Laser-Induced Fluorescence

IMAGING OF VAPOR/LIQUID DISTRIBUTIONS OF SPLIT-INJECTED DIESEL SPRAYS IN A TWO-DIMENSIONAL MODEL COMBUSTION CHAMBER

Quantitative Gaseous Temperature and Mole Concentration Measurements in Spray Generated Mixture by P-Xylene-plif Imaging

Dual-Wavelength Laser-Absorption-Scattering (LAS) Technique for Mixture Concentration Distribution Measurement of Gasoline Spray

Quantitative acetone/toluene planar laser‐induced fluorescence measurements of equivalent ratio

Laser Sheet Dropsizing of Evaporating Sprays Using Simultaneous Lief/Mie Techniques

Ambient Tracer-LIF for 2-D Quantitative Measurement of Fuel Concentration in Gas Jets

Evaporation Characterization Of Fuel Spray Impinging On A Flat Wall By Laser-Based Measurement

A Method for Measuring Planar Sauter Mean Diameter of Multi-Component Fuel Spray Based on the Combined Statistical Extinction Tomography and Particle Imaging Velocimetry

Simultaneous Quantitative Imaging of Temperature and H2O/CH2O Concentration by Using LAS-Fused Nd-YAG Laser-Induced Fluorescence

Laser-based Measurements and Analyses on Cycle-to-cycle Variations of Mixture Formation in Binary-Component Fuel Sprays