Abstract:Porous iron oxides are being evaluated and selected for arsenic removal in potable water systems. Granular ferric hydroxide, a typical porous iron adsorbent, is commercially available and frequently considered in evaluation of arsenic removal methods. GFH is a highly porous (micropore volume approximately 0.0394+/-0.0056 cm(3)g(-1), mesopore volume approximately 0.0995+/-0.0096 cm(3)g(-1)) adsorbent with a BET surface area of 235+/-8 m(2)g(-1). The purpose of this paper is to quantify arsenate adsorption kinetics on GFH and to determine if intraparticle diffusion is a rate-limiting step for arsenic removal in packed-bed treatment systems. Data from bottle-point isotherm and differential column batch reactor (DCBR) experiments were used to estimate Freundlich isotherm parameters (K and 1/n) as well as kinetic parameters describing mass transfer resistances due to film diffusion (k(f)) and intraparticle surface diffusion (D(s)). The pseudo-equilibrium (18 days of contact time) arsenate adsorption density at pH 7 was 8 microg As/mg dry GFH at a liquid phase arsenate concentration of 10 microg As/L. The homogeneous surface diffusion model (HSDM) was used to describe the DCBR data. A non-linear relationship (D(S)=3.0(-9) x R(p)(1.4)) was observed between D(s) and GFH particle radius (R(P)) with D(s) values ranging from 2.98 x 10(-12) cm(2)s(-1) for the smallest GFH mesh size (100 x 140) to 64 x 10(-11) cm(2)s(-1) for the largest GFH mesh size (10 x 30). The rate-limiting process of intraparticle surface diffusion for arsenate adsorption by porous iron oxides appears analogous to organic compound adsorption by activated carbon despite differences in adsorption mechanisms (inner-sphere complexes for As versus hydrophobic interactions for organic contaminants). The findings are discussed in the context of intraparticle surface diffusion affecting packed-bed treatment system design and application of rapid small-scale column tests (RSSCTs) to simulate the performance of pilot- or full-scale systems at the bench-scale.

Adsorption of Arsenate from Groundwater Through a Fixed Bed Using Iron-Coated Natural Fibres: Reusability and Sorbent Characterisation

Application of iron-modified kapok fibres for As(V) removal from groundwater using column fixed bed approach

Fixed-bed column method for removing arsenate from groundwater using aluminium-modified kapok fibres

Adsorption Performance of Fe(III) Modified Kapok Fiber for As(V) Removal from Water

Fast arsenate As(V) adsorption and removal from water using aluminium Al(III) fixed on Kapok fibres

Comparison of two carbonaceous supported Fe-rich adsorbents for arsenate removal: A functionalisation and mechanistic study with applicability to groundwater treatment

Characterisation of kapok fibre's biochar for arsenate adsorption removal from aqueous solution.

Treatment of arsenic-contaminated groundwater with a novel iron oxide/carbon composite as the adsorbent

Efficient Removal of Arsenic from Groundwater Using Iron Oxide Nanoneedle Array-Decorated Biochar Fibers with High Fe Utilization and Fast Adsorption Kinetics

Arsenic Removal from Contaminated Water Using Natural Adsorbents: A Review

Removal of arsenic from waters using montmorillonite KSF as adsorbent

Characterisation of Aluminium-Coated Biochar (kapok) for Arsenate Removal from Aqueous Solution

Batch study of arsenate (V) adsorption using Akadama mud: Effect of water mineralization

Arsenic adsorption behaviors of backwash sludge from waterworks for iron and manganese removal

Synthesis and Characterization of an Iron-Impregnated Biochar for Aqueous Arsenic Removal.

Study on the removal of arsenic by in-situ formed Fe-based adsorbent in filtration process

Intraparticle diffusion and adsorption of arsenate onto granular ferric hydroxide (GFH)

Ultrafast and Deep Removal of Arsenic in High-Concentration Wastewater: A Superior Bulk Adsorbent of Porous Fe2O3 Nanocubes-Impregnated Graphene Aerogel

Effects of Solution Chemistry on Arsenic(v) Removal by Low-Cost Adsorbents.

[Arsenic(ⅴ) Removal by Granular Adsorbents Made from Backwashing Residuals from Biofilters for Iron and Manganese Removal].

Arsenite and Arsenate Removal from Contaminated Groundwater by Nanoscale Iron–Manganese Binary Oxides: Column Studies