Abstract:With the rapid development and broad applications of unmanned aerial vehicle (UAV)-based wireless stations in the sky, fundamental understanding and characterization of the realistic air-to-ground (A2G) communication link properties are crucial. In this article, a UAV-aided channel sounder with a real-time processing hardware system is developed for highly dynamic and nonstationary A2G channel measurements. In the hardware system, a global positioning system (GPS)-based triggering signal is designed, the equivalent antenna pattern affected by the UAV airframe is considered, and an appropriate sounding signal is selected, to improve the accuracy of measured channel impulse response (CIR). Moreover, real-time hardware processing algorithms for raw channel data, that is, CIR extraction, system response elimination (SRE), power loss recovery (PLR), and adaptive multipath component (MPC) recognition are developed and implemented on a single field-programmable gate array (FPGA) chip. In this way, the required storage size of channel data and the processing time for one slice of CIR is greatly decreased, which can meet the requirement of nonstationary A2G channel measurement with a high sampling rate and long-time measurement. A commercial channel emulator is used to reproduce controllable channels and verify the performance of the developed channel sounder. Finally, the developed channel sounder is applied to carry out A2G measurement campaigns at 3.5 GHz in a campus scenario. The channel characteristics, that is, path loss (PL), -factor, and path angle are analyzed. The measured channel characteristics are consistent with existing measurements under a similar scenario. The estimated path angles are also validated by the theoretical results. Thus, the channel sounder can be used to capture the nonstationary A2G channel characteristics for the system design and algorithm optimization of A2G commun- cations.

Antenna Measurement in Outdoor Environment Based on a Unmanned Aerial Vehicle

Antenna for Wireless Communications on Unmanned Aerial Vehicles

An Unmanned Aerial Vehicle Antenna Array

Motion Measurement of Sar Antenna Based on High Frame Rate Camera

Research of Antenna Planar Near-Field Measurement System in Time-Domain

Electromagnetics-Aware Path for UAV-Based Near-Field Antenna Measurements Implemented With a High Dynamic Range SDR

Impact of 3D Antenna Radiation Pattern in UAV Air-to-Ground Path Loss Modeling and RSRP-based Localization in Rural Area

A UAV-Aided Real-Time Channel Sounder for Highly Dynamic Nonstationary A2G Scenarios

Design and Installed Performance Analysis of a Miniaturized All-GNSS Bands Antenna Array for Robust Navigation on UAV Platforms

A Compact Dual-band Omnidirectional Circularly Polarized Filtering Antenna for UAV Communications

Experimental Evaluation of Air-to-Ground VHF Band Communication for UAV Relays

Path Loss Measurement And Modeling For Low-Altitude Uav Access Channels

A Simple System for Measuring Antenna Radiation Patterns in the Wi-Fi Band

Novel Pattern-Diverse Millimeter-Wave Antenna with Broadband, High-Gain, Enhanced-Coverage for Energy-Efficient Unmanned Aerial Vehicle.

Ground-to-UAV sub-Terahertz channel measurement and modeling

Over-the-air Noise Temperature Measurement

Measurement and Analysis of Antenna Pattern for MIMO HF Surface Wave Radar

Large FoV Direction-Finding System Based on A Small-Aperture Phase Mode Antenna and Its Applications on UAVs

Research on a Method of Locating Civil Aviation Radio Interference Sources Based on Time Difference of Arrival and Frequency Difference of Arrival for Four Unmanned Aerial Vehicles

Joint Microwave and Millimeter-Wave Antenna Design for UAV-Enabled Communications

A Survey on Channel Sounding Technologies and Measurements for UAV-Assisted Communications