Abstract:In recent years, wearable monitoring devices have been very popular in the health care field and are being used to avoid sport injuries during exercise. They are usually worn on the wrist, the same as sport watches, or on the chest, like an electrocardiogram patch. Common functions of these wearable devices are that they use real time to display the state of health of the body, and they are all small sized. The electromyogram (EMG) signal is usually used to show muscle activity. Thus, the EMG signal could be used to determine the muscle-fatigue conditions. In this study, the goal is to develop an EMG patch which could be worn on the lower leg, the gastrocnemius muscle, to detect real-time muscle fatigue while exercising. A micro controller unit (MCU) in the EMG patch is part of an ARM Cortex-M4 processor, which is used to measure the median frequency (MF) of an EMG signal in real time. When the muscle starts showing tiredness, the median frequency will shift to a low frequency. In order to delete the noise of the isotonic EMG signal, the EMG patch has to run the empirical mode decomposition algorithm. A two-electrode circuit was designed to measure the EMG signal. The maximum power consumption of the EMG patch was about 39.5 mAh. In order to verify that the real-time MF values measured by the EMG patch were close to the off-line MF values measured by the computer system, we used the root-mean-square value to estimate the difference in the real-time MF values and the off-line MF values. There were 20 participants that rode an exercise bicycle at different speeds. Their EMG signals were recorded with an EMG patch and a physiological measurement system at the same time. Every participant rode the exercise bicycle twice. The averaged root-mean-square values were 2.86 ± 0.86 Hz and 2.56 ± 0.47 Hz for the first and second time, respectively. Moreover, we also developed an application program implemented on a smart phone to display the participants’ muscle-fatigue conditions and information while exercising. Therefore, the EMG patch designed in this study could monitor the muscle-fatigue conditions to avoid sport injuries while exercising.

Design of a Lumbar Muscle Fatigue Monitoring System Based on Electrical Impedance Myography

Analysis of Electrical Impedance Myography Electrodes Configuration for Local Muscle Fatigue Evaluation Based on Finite Element Method

Low Back Muscle Fatigue Monitoring Using Proprietary Electrical Impedance Myography System.

Electrical Impedance Myography Applied to Monitoring of Muscle Fatigue During Dynamic Contractions.

Design of a Wireless Distributed Real-time Muscle Fatigue Detection System.

Detection of Low Back Muscle State Based on Electrical Impedance Myography

An EMG Patch for the Real-Time Monitoring of Muscle-Fatigue Conditions During Exercise

A Wearable, Multi-Frequency Device to Measure Muscle Activity Combining Simultaneous Electromyography and Electrical Impedance Myography

Electrical Impedance Myography for Evaluating Muscle Fatigue Induced by Neuromuscular Electrical Stimulation

A Wireless sEMG Recording System and Its Application to Muscle Fatigue Detection

A Flexible Wireless sEMG System for Wearable Muscle Strength and Fatigue Monitoring in Real Time

ANew Non-invasive Marker of Muscle Fatigue Based on Electrical Impedance Myography

Advancements and Challenges in Electrical Impedance Myography (EIM): A Comprehensive Overview of Technology Development, Applications in Sports Health, and Future Directions

Exercise muscle fatigue detection system implementation via wireless surface electromyography and empirical mode decomposition

Wearable Ifemg Sensor for Muscle Strength Evaluation

Implementation of a Portable Electromyographic Prototype for the Detection of Muscle Fatigue

Muscle Electrical Impedance Analysis Based on Blind Source Separation

[Design and Experimental Research of Synchronous Acquisition System of EMG and Blood Oxygen Signal]

Real-time Monitoring Algorithm of Muscle State Based on sEMG Signal

Muscle fatigue detection and treatment system driven by internet of things

Assessment of Muscle Fatigue Based on Motor Unit Firing, Muscular Vibration and Oxygenation via Hybrid Mini-Grid sEMG, MMG, and NIRS Sensing