Abstract:Towards latent heat storage in the low-to-medium temperature range (70-250 degrees C), screening of sugar alcohols and their binary eutectic mixtures as potential phase change materials was carried out by focusing on the non-isothermal melting and crystallization behaviors. A preliminary screening shortened the long list of isomers from common four-carbon to six-carbon sugar alcohols to only six affordable candidates, i.e., xylitol, d-sorbitol, erythritol, d-mannitol, d-dulcitol and inositol (ordered with increasing the melting point). Based on the six pre-screened sugar alcohols, a total of 15 binary eutectic mixtures were prepared to manipulate the melting points for more flexible match with real applications. Non-isothermal tests were then performed on a differential scanning calorimeter at various ramping/cooling rates up to 10 degrees C/min. In addition to determination of the melting point and latent heat of fusion, a special attention was paid to the crystallization behaviors by undertaking consecutive melting-crystallization cyclic tests. It was found that the two candidates with the lowest melting points (both below 100 degrees C), i.e., xylitol and d-sorbitol, as well as the nine binary eutectic mixtures containing at least one of them, are unable to crystallize from the melt during cool-down at any cooling rates tested (down to 0.5 degrees C/min). Four other binary eutectic mixtures, i.e., erythritol (84 mol%) + d-mannitol, erythritol (95 mol%) + d-dulcitol, erythritol (96 mol%) + inositol and d-dulcitol (69 mol%) + inositol, were also shown to be unable to crystallize upon cooling, with the crystallization occurring during the reheating process instead, referred to as cold crystallization. The rest four pure sugar alcohols with relatively high melting points (110-230 degrees C), i.e., erythritol, d-mannitol, d-dulcitol, inositol, and two mixtures, i.e., d-mannitol (70 mol%) + d-dulcitol and d-mannitol (82 mol%) +inositol, were found to be able to crystallize upon cooling, although they all suffer from severe supercooling (e.g., up to over 100 degrees C for erythritol). The affordable pure and mixture sugar alcohols were deemed to have desirably high latent heat storage density, especially for those with higher melting points. However, they all face specific issues associated with crystallization, which must be addressed before they can really be utilized in real applications. In addition, it may not worth making eutectic mixtures, although this is deemed to be an effective way of manipulating the melting points of sugar alcohols. (C) 2018 Elsevier Ltd. All rights reserved.

A Comprehensive Evaluation on the Cycling Stability of Sugar Alcohols for Medium-Temperature Latent Heat Storage

Screening of Sugar Alcohols and Their Binary Eutectic Mixtures As Phase Change Materials for Low-to-medium Temperature Thermal Energy Storage. (Ⅱ): Isothermal Melting and Crystallization Behaviors

Non-isothermal characterization on thermal storage/release performance of sugar alcohols and their binary eutectic mixtures

Screening of Sugar Alcohols and Their Binary Eutectic Mixtures As Phase Change Materials for Low-to-medium Temperature Latent Heat Storage. (Ⅰ): Non-isothermal Melting and Crystallization Behaviors

NON-ISOTHERMAL PHASE CHANGE BEHAVIORS OF BINARY MIXTURES OF DDULCITOL AND PENTAERYTHRITOL AS NOVEL HEAT STORAGE MATERIALS

Temperature-Dependent Rheological Behaviors of Binary Eutectic Mixtures of Sugar Alcohols for Latent Heat Storage: A Comparative Study with Pure Sugar Alcohols

Rheological behaviors of sugar alcohols for low-to-medium temperature latent heat storage: Effects of temperature in both the molten and supercooled liquid states

Sugar alcohol phase change materials for low-to-medium temperature thermal energy storage: A comprehensive review

Suppressing the Supercooling Effect of Erythritol by Bubbling for Latent Heat Storage

Interfacial Heat Transfer Between Erythritol and Xylitol Crystals As a Mixture Heat Storage Material

D-mannitol@silica/graphene Oxide Nanoencapsulated Phase Change Material with High Phase Change Properties and Thermal Reliability

Screening of sugar alcohols and their binary eutectic mixtures as phase change materials for low-to-medium temperature thermal energy storage. (III): Thermal endurance

Thermal property optimization and shape stabilization of sugar alcohols phase change thermal energy storage materials reinforced by sintering synthesized alumina porous ceramics

Atomistic insights into the effects of hydrogen bonds on the melting process and heat conduction of erythritol as a promising latent heat storage material

Contribution of the Hydroxyl Group on Interfacial Heat Conduction of Monohydric Alcohols: A Molecular Dynamics Study

Thermal storage performance of eutectic sugar alcohols applied to buildings and enhancement of crystallization

Synthesis and properties of nanoencapsulated D-mannitol for medium temperature thermal energy storage

Bubble-injection-enabled significant reduction of supercooling and controllable triggering of crystallization of erythritol for medium-temperature thermal energy storage

Development of Renewable Biomass-Derived Carbonaceous Aerogel/Mannitol Phase-Change Composites for High Thermal-Energy-Release Efficiency and Shape Stabilization

Investigation on thermal energy storage characteristics of form-stable phase change materials supported by graphene aerogel

Experimental Study of Screening Polyols and Their Binary Eutectic Phase Change Materials for Long-Term Thermal Energy Storage