Abstract:Air compressor is a main power equipment, and improving its reliability and security is important to enhance the competitiveness of pneumatic companies. This study proposes a real monitored data-based fault measure and early warning system for air compressor, which can guide field workers in economically and safely operating the air compressor by finding and dealing with faults ahead of time. A data-driven multivariate state estimation technique (MSET) is utilized to construct the non-parametric fault early warning model under normal operating condition, principal components analysis (PCA) and back propagation (BP) method are combined to construct the dynamic memory matrix and simplify the model. With the pre-built PCA-BP-MSET model, optimal values of the observed vectors are estimated and a deviation function is defined to calculated the deviation sequence between the estimated and observed vectors, where the qualitative-quantitative combined AHP method is adopted to determine the weights of the monitored variables. With the deviation sequence, the sliding window statistical method is applied to determine the fault early warming threshold, which can be used as a benchmark to measure and warn the fault of air compressor. The fault warning information of an air compressor is given out once the deviation degree of some observed vector exceeds the threshold, thereby realizing the function of fault measure and early warning in advance. In addition, an automatically updating method is proposed to ensure the accuracy of the PCA-BP-MSET model in case of the changes of running states. For verification, a real fault case of an air compressor has been chosen to verify the effectiveness of the proposed method. Result shows that the PCA-BP-MSET-based method can catch the fault developing process timely, which is appropriate for the faults prevention and rapid troubleshooting of air compressor.

Early warning and diagnosis of primary fans based on improved MSET

A hybrid data-driven modeling method on sensor condition monitoring and fault diagnosis for power plants

Wind turbine condition monitoring based on a novel multivariate state estimation technique

Wind Turbine Fault Detection with Multimodule Feature Extraction Network and Adaptive Strategy

An Adaptive Early Fault Detection Model of Induced Draft Fans Based on Multivariate State Estimation Technique

Condition monitoring of wind turbine based on incremental learning and multivariate state estimation technique

An Early Warning Model for Turbine Intermediate-Stage Flux Failure Based on an Improved HEOA Algorithm Optimizing DMSE-GRU Model

Research on early fault warning methods for key transmission components of wind turbines

Fault Detection of Wind Turbine Generator Bearing Using Attention-Based Neural Networks and Voting-Based Strategy

Design and Application of Online Fault Warning and Diagnosis Integrated System for Wind Turbines

An early fault warning and diagnosis model based on a two-step analysis strategy for wind turbine bearings

Study on novel signal processing and simultaneous-fault diagnostic method for wind turbine

Research on Fault Detection Method of Wind Turbine Generator Based on SCADA Data

An Unsupervised Fault Warning Method Based on Hybrid Information Gain and a Convolutional Autoencoder for Steam Turbines

A novel fault measure and early warning system for air compressor

A Hierarchical Modeling Strategy for Condition Monitoring and Fault Diagnosis of Wind Turbine Using SCADA Data

Study of Wind Turbine Fault Diagnosis and Early Warning Based on SCADA Data

Early Fault Detection of Wind Turbines Based on Operational Condition Clustering and Optimized Deep Belief Network Modeling

SCADA-data-based wind turbine fault detection: A dynamic model sensor method

Multivariate state estimation-based condition monitoring of slurry circulating pumps for wet flue gas desulfurization of power plants

Two-Stage Cascaded High-Precision Early Warning of Wind Turbine Faults Based on Machine Learning and Data Graphization