Abstract:With the aggravation of the energy crisis and environmental problems, the new energy electric vehicle industry has ushered in vigorous development. However, with the continuous increase in car ownership, traffic accidents and other issues have gradually attracted widespread attention. Some existing stability coordination control systems often have problems, such as single stability judgment method and strong coupling between different subsystems. Therefore, based on previous research, it is necessary to further optimize the method of judging the vehicle’s stability state, establish clear coordination rules, and reasonably solve the coupling problem between subsystems. This is of great significance for promoting the further development of the electric vehicle industry. Due to four-wheel-distributed driving and four-wheel-distributed steering electric vehicles having the characteristics of integrated driving, flexible steering, and easy fault-tolerant control, it has unique advantages in improving vehicle stability and is a good carrier for designing and constructing the stability coordination control system. In this paper, four-wheel-distributed driving and four-wheel-distributed steering (4WD-4WS) electric vehicles are taken as the research object, and a coordinated control strategy of four-wheel steering and four-wheel drive is proposed. Firstly, in order to realize the accurate judgment of vehicle stability, based on the vehicle two-degree-of-freedom two-track model and magic tire model, this paper uses the phase plane law to divide the phase plane stability region of the vehicle and introduces the stability quantification index PPS-region for the evaluation of vehicle stability. Secondly, a fuzzy variable parameter active rear-wheel steering controller and a compensated yaw moment controller are designed. Then, for the coupling problem between the two controllers, a coordination rule is proposed based on the stability index PPS-region of the phase plane stability region. Finally, a hardware-in-the-loop testbed is built to verify the feasibility of the coordination control strategy proposed in this paper. Experimental results show that: When the vehicle is in different stable states, according to the divided steady state, the control strategy can be correctly switched to the corresponding control strategy, and the work of each subsystem can be reasonably coordinated. Under the continuous gain sine condition, the control algorithm can reduce the maximum amplitude of the yaw rate error response curve by 73% and the side slip angle error response curve by 85%. Compared with a single stability control system, the coordinated stability control algorithm can improve the control effect of yaw rate and side slip angle by 20% and 62.5%. In the case of double lane-change, the control algorithm can reduce the maximum amplitude of the yaw rate error response curve by 68.5% and the side slip angle error response curve by 57.4%. Compared with a single stability control system, the coordinated stability control algorithm can improve the control effect of yaw rate and side slip angle by 40.6% and 44.7%.

Integrated Dynamics Control for Path Tracking and Obstacle Avoidance of Four-Wheel Intelligent Distributed Drive Vehicles Based on Time-Varying Predictive Control

Robust path following control of 4WID autonomous vehicle with driving condition adaptive mechanism

Path tracking coordinated control strategy for autonomous four in-wheel-motor independent-drive vehicles with consideration of lateral stability

A Dynamics Coordinated Control System for 4WD-4WS Electric Vehicles

Trajectory tracking of four-wheel driving and steering autonomous vehicle under extreme obstacle avoidance condition

Trajectory tracking control for four-wheel independent drive intelligent vehicle based on model predictive control and sliding mode control

Coordinated strategy for path tracking and dynamic stability considering extreme obstacle avoidance in distributed drive electric vehicles

Trajectory Tracking Control for Four-Wheel Independently Driven Electric Vehicle Based on Model Predictive Control and Sliding Model Control

Design of Four Wheel Steering and Direct Yaw Moment Control for Unmanned Vehicle with Path Tracking Controller in Extreme Maneuvers

Path Tracking and Direct Yaw Moment Coordinated Control Based on Robust MPC With the Finite Time Horizon for Autonomous Independent-Drive Vehicles

Yaw rate tracking-based path-following control for four-wheel independent driving and four-wheel independent steering autonomous vehicles considering the coordination with dynamics stability

Integrated Longitudinal and Lateral Vehicle Stability Control for Extreme Conditions With Safety Dynamic Requirements Analysis

Hierarchical Model Predictive Control for Autonomous Collision Avoidance of Distributed Electric Drive Vehicle with Lateral Stability Analysis in Extreme Scenarios

MPC-Based Integrated Control of Trajectory Tracking and Handling Stability for Intelligent Driving Vehicle Driven by Four Hub Motor

Dynamic Decoupling and Trajectory Tracking for Automated Vehicles Based on the Inverse System

Speed-Varying Path Tracking Based on Model Predictive Control for Autonomous Vehicles

Coordinated Control for the Trajectory Tracking of Four-Wheel Independent Drive–Four-Wheel Independent Steering Electric Vehicles Based on the Extension Dynamic Stability Domain

Path Planning and Obstacle Avoidance Control for Autonomous Multi-Axis Distributed Vehicle Based on Dynamic Constraints

An Optimized Control Strategy Based on Hierarchical Design, 4WS-4WD, NMPC, and Nonlinear Dynamics Models

Optimal Predictive Control for Path Following of a Full Drive-by-Wire Vehicle at Varying Speeds