Abstract:Parallel microchannels have been widely used in cooling of compact electronic equipment due to large contact area with liquid and availability of large mass of fluid to carry away heat. However, understanding of flow distribution for microchannel parallel system is still unclear and there still lack of studies give a clear pictures to understand the complex flow features which cause the flow maldistribution. Generally, the geometrical structure of the manifold and micro channels play an important role in flow distribution between micro channels, which might affects the heat and mass transfer efficiency, even the performance of micro exchangers. A practical design of exchanger basically involves the selection of an optimized solution, keeping an optimal balance between gain in heat transfer and pressure drop penalty. A parallel microchannels configurations consisting inlet and outlet rectangular manifold were simulated to study flow distribution among the channels were investigated numerically by using Ansys Fluent 14.5. The numerical results was validated using existing experimental data and showed a similar trend with values 1% higher than experimental data. The influence of inlet/outlet manifold area and inlet/outlet arrangement on flow distribution in channels were carried out in this study. Based on the predicted flow non-uniformity value, 𝜙, Z- type flow arrangement exhibits higher value of 𝜙, which is 8%, followed by U-type, 2.6% and the I-type, 2.49%. Thus, a better uniformity of velocity and temperature distributions can be achieved in I-shape flow arrangement. The behavior of the flow distributions inside channels is due to the vortices that occurred at manifold. Besides comparing the pressure drop for case 1(D1) and case 2(D2), it is worth to mention that, as the area of inlet and outlet manifold decrease by 50%, the pressure drop is increasing about 5%. However, the inlet/outlet area of manifold on velocity and fluid temperature distributions was insignificant.

Numerical Study on Flow Distribution Characteristics of Parallel Square Flow Channels Under Blockage

Numerical Study on Performances of Mini-Channel Heat Sinks with Non-Uniform Inlets

The Inlet Flow Blockage Accidents Analysis in the Rectangular Flow Channel of Water Cooled Blanket

Numerical Calculation of Flow Heat Transfer in a Single Square Tube Under a Blockage Accident

Numerical Computations of the Flow in A Finite Diverging Channel

Numerical simulation of single-phase flow in a single square tube with blockage

NUMERICAL STUDY OF THE EFFECT OF AREA OF MANIFOLD AND INLET/OUTLET FLOW ARRANGEMENT 0N FLOW DISTRIBUTION IN PARALLEL RECTANGULAR MICROCHANNEL COOLING SYSTEM

Effect of Inlet/Outlet types on the Flow Distribution and Heat Transfer in Mini-Channels

Numerical Investigation of Flow and Heat Transfer Characteristics in Plate-Type Fuel Channels of IAEA MTR Based on OpenFOAM

Experimental Study on Flow Patterns in Narrow Rectangular Channels

Development of Thermal Hydraulic Analysis Code of Annular Fuel under Flow Blockage Condition

Fluid Flow and Conjugate Heat Transfer in a Channel with Inflow from a Porous Wall

Numerical Simulation of the Effect of the Test Section Shape on the Flow Field in a Minitype High-speed Water-tunnel

Numerical Simulation of Laminar Heat Transfer of Equal Wall Temperature in Parallel Micro Channel

Flow Distribution and Heat Transfer Performance of Two-Phase Flow in Parallel Flow Heat Exchange System

Effect of Blocked Core-Tube Diameter on Heat Transfer Performance of Internally Longitudinal Finned Tubes

Cfd Study on Inlet Flow Blockage Accidents in Rectangular Fuel Assembly

ICONE23-1845 CFD STUDY ON INLET FLOW BLOCKAGE ACCIDENTS IN MULTI-LAYER ANNULAR FLOW CHANNELS

Theoretical study on the characteristics of critical heat flux in vertical narrow rectangular channels

Numerical investigation of flow blockage accident in SFR fuel assembly

Numerical study on the effect of a parallel to the flow barrier on the flow and heat transfer characteristics of a symmetric sinusoidal channels