Explanation for paradox in natural frequency calculation of cantilever fluid-conveying pipe system with an end-mass

ZHAO Guixin,MENG Shuai,CHE Chidong,CHEN Li
DOI: https://doi.org/10.13465/j.cnki.jvs.2023.07.003
2023-01-01
Abstract:Once deep-sea drilling system is disconnected in an emergency case, drilling fluid needs to be discharged into sea to prevent resonance failure caused due to natural frequencies of suspension riser system being close to wave frequencies. At the same time, sea water must be injected into riper to prevent riper collapse. At this time, cantilever riser mechanism is a typical cantilever fluid-conveying pipe system with low end concentrated mass, i.e., low end assembly. When Galerkin method is used to calculate the system’s natural frequencies, usually two ways are employed including the end-mass being taken as a boundary condition, and Dirac function being adopt to embed the end-mass into the pipe model. When the internal flow velocity is zero, the results using the two ways are consistent. However, when the internal flow velocity is not zero, the calculation results using the two ways are quite different. Pa6doussis pointed out that at this time, the first way is wrong. But they did not give a reasonable explanation. Here, the orthogonal condition of natural modes of a cantilever beam system was re-deduced when the end-mass was used as a boundary condition, and an improved method was proposed for re-calculation. The new results were compared with those using the second way and those published in literature for verification. By comparing the new results with test results of the internal flow effect of cantilever fluid-conveying pipe system with an end-mass, it was shown that the improved method proposed here can correctly predict the critical internal flow velocity and unstable vibration frequencies; it can explain the paradox in natural frequency calculation of cantilever fluid-conveying pipe system with an end-mass, and provide a reference for dynamic analysis of fluid-conveying pipe systems under different boundary conditions.
What problem does this paper attempt to address?