Abstract:Hybrid calcium carbonate particles, synthesized III the presence of block copolymer polystyrene-b-poly(acrylic acid) (PS-b-PAA), were used to fabricate polyelectrolyte (PE) such as polylallyamine hydrochloride)/ poly(strene sulfonate sodium) (PAH/PSS) and poly (diallyldimethyl ammonium chloride)/poly (styrene sulforate sodium) (PADH/PSS) Capsules, by layer-by-layer (LbL) technique. Novel micelle-enhanced polyelectrolyte (PE capsules were thus obtained. The structure of the micelle-enhanced PE microcapsules was studied in this article. Due to the presence of a large amount of negatively charged micelles inside PE capsule interior, which were liberated from templates, the capsule wall was tightly re-constructed. Different from the wall properties of the conventional PE capsules, the wall of the micelle-enhanced PE capsules showed stability under an extensive pH range from I to 14, but the micelled enhanced capsules showed dented morphology in solutions with high NaCl concentration such as 0.5 mol/L and I mol/L. The state of the block copolymer in the capsules was investigated in dialysis bag by simulating the Solution condition of the capsule interior after the template being removed. It was found that the micelle size of the block copolymer In solution of templates dissolution was tens of nanometers after the solution was dialyzed for 24 h. With the dialysis time increasing up to at least 72 It, the block copolymer began to precipitate onto the dialysis bag from the solution The interaction between the 2-D polyelectrolyte multilayer film and micelles formed by block copolymer in templates solution was studied by UV-Vis measurements as well. It was found that PE multilayer could interact with micelles via electrostatic force. At the same time I the block copolymer remained in the capsules interior could be precipitated onto the PE multilayer via dialyzing in deionized water for a long time (pH similar to 6). A micelle-related layer was formed which was stabilized by the "bridge effect" of calcium ions. That is, the wall of the micelle-enhanced PE capsules had a bilayer structure and was formed by the polyelectrolyte multilayer and micelle-related layer. It seemed that the two layers with different properties clung to each other via electrostatic force. The formation mechanism of the bilayer structure was well illuminated oil the aforementioned studies. This is a key property of the micelle-enhanced PE capsules with which all the properties of the capsules were linked. Based on the bilayer structure of the capsules, the morphology changes of the capsules in solutions with different conditions such as high NaCl concentrations could be elucidated well. However, more direct proofs and further studies were needed to completely resolve the fine structure of the micelle-enhanced PE capsules.

Comparison of Structure and Properties of Different Linear Dextrin-based DHA Microcapsules

Developing DHA microcapsules using linear dextrin aggregates of different chain length distributions

Preparation of "micelles enhanced " polyelectrolyte capsules

Intestinal absorption of DHA microcapsules with different formulations based on ex vivo rat intestine and in vitro dialysis models

The effect of octenyl succinic anhydride-modified chitosan coating on DHA-loaded nanoemulsions: Physichemical stability and in vitro digestibility

Structure Studies of Micelle-Enhanced Polyelectrolyte Microcapsules

Impact of wall materials and DHA sources on the release, digestion and absorption of DHA microcapsules: Advancements, challenges and future directions

Comparison of the Digestion and Absorption Characteristics of Docosahexaenoic Acid-Acylated Astaxanthin Monoester and Diester in Mice

Effects of side-chain lengths on the structure and properties of anhydrides modified starch micelles: Experimental and DPD simulation studies

Novel medium-and long-chain triacylglycerols rich structured lipids enriched in n-3 polysaturated fatty acids encapsulated by spray drying: Characterization and stability

Fabrication, Characterization and Properties of DHA-loaded Nanoparticles Based on Zein and PLGA

Synthesis and Characterization of Emulsifiers Based on the Maillard Reaction and Its Application in Stabilized DHA Algal Oil Nanoemulsions

Preparation, Characterization of PLGA/chitosan Nanoparticles As a Delivery System for Controlled Release of DHA.

Amylose Complexation with Diacylglycerols Involves Multiple Intermolecular Interaction Mechanisms

Use of Sodium Alginate Coatings to Improve Bioavailability of Liposomes Containing DPP-IV Inhibitory Collagen Peptides.

In Vivo Absorption and Lymphatic Bioavailability of Docosahexaenoic Acid from Microalgal Oil According to Its Physical and Chemical Form of Vectorization

Evaluating Structural Properties and Stable Sustained Release Mechanism of W-3 Fatty Acid Enriched Microcapsules Prepared with Multi-Component Composite Wall Materials

Effect of Arabinoxylan Amount and Molecular Structure on the Microstructure, Physicochemical and Delivery Properties of Casein/arabinoxylan Composite Hydrogels

Development and optimization of spray‐dried functional oil microcapsules: Oxidation stability and release kinetics

Multi-scale Structural Features and Thermal Stabilities of Acylated Starch with Different Acyl Groups