Catalytic Combustion of Biodiesel Wastewater over the Fe2O3 Catalyst Coupled with a Pt-based Catalyst
Shangzhi Yu,Wenyu Yuan,Jianfeng Bai,Qinglong Xie,Xiaojiang Liang,Yong Nie
DOI: https://doi.org/10.1039/d4ew00259h
2024-01-01
Abstract:In this paper, biodiesel wastewater was treated by catalytic combustion in the case of catalyst coupling. The effects of reaction temperature, residence time and air flow on the treatment of biodiesel wastewater were investigated using the Fe2O3 catalyst, the Pt/Al2O3@cordierite catalyst and the Fe2O3 catalyst coupled with the Pt-based catalyst. The effects of high-temperature hydrothermal treatment on the two catalysts were evaluated. The catalytic stability was studied in continuous catalytic combustion. Detailed characterization of the two catalysts was carried out. The X-ray fluorescence (XRF), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) characterization demonstrated that the Fe2O3 catalyst contained a significant amount of surface active oxygen and Fe2O3 existed in an amorphous form within the catalyst. The Fe2O3 catalyst could remove 90.6% of sulfur from wastewater, showing excellent desulfurization performance, but it was not resistant to high temperature. After 500 degrees C hydrothermal treatment, the chemical oxygen demand (COD) removal rate decreased significantly from 97.98% to 69.04% at the reaction temperature of 280 degrees C. The COD removal rate of the Pt/Al2O3@cordierite catalyst was almost 100% at the reaction temperature of 320 degrees C, with the activity being basically unchanged after high-temperature hydrothermal treatment, but sulfur poisoning occurred. The Fe2O3 catalyst coupled with the Pt/Al2O3@cordierite catalyst showed excellent catalytic activity and stability, and the optimal reaction temperature and residence time were 320 degrees C and 0.3 s, respectively. In the continuous treatment of biodiesel wastewater with the COD of 99 465 mg L-1 for 200 h, the COD and sulfur content of the treated wastewater were less than 400 mg L-1 and 1 mg L-1, with the COD removal rate and sulfur removal rate exceeding 99.62% and 81.38%, respectively. In addition, no organic gas or SO2 was detected in the exhaust gas generated during the reaction, and the removed organic matter was converted into CO2 and H2O.