Abstract:Abstract We combine steady-state measurements of relative permeability with pore-scale imaging to estimate local capillary pressure. High-resolution three-dimensional X-ray tomography enables the pore structure and fluid distribution to be quantified at reservoir temperatures and pressures with a resolution of a few microns. Two phases are injected through small cylindrical samples at a series of fractional flows until the pressure differential across the core is constant. Then high-quality images are acquired from which saturation is calculated, using differential imaging to quantify the phase distributions in micro-porosity which cannot be explicitly resolved. The relative permeability is obtained from the pressure drop and fractional flow, as in conventional measurements. The curvature of the fluid/fluid interfaces in the larger pore spaces is found, then from the Young-Laplace equation, the capillary pressure is calculated. In addition, the sequence of images of fluid distribution captures the displacement process. Observed gradients in capillary pressure – the capillary end effect – can be accounted for analytically in the calculation of relative permeability. We illustrate our approach with three examples of increasing complexity. First, we compare the measured relative permeability and capillary pressure for Bentheimer sandstone, both for a clean sample and a mixed-wet core that had been aged in reservoir crude oil after centrifugation. We characterize the distribution of contact angles to demonstrate that the mixed-wet sample has a wide range of angle centred, approximately, on 90°. We then study a water-wet micro-porous carbonate to illustrate the impact of sub-resolution porosity on the flow behaviour: here oil, as the non-wetting phase, is present in both the macro-pores and micro-porosity. Finally, we present results for a mixed-wet reservoir carbonate. We show that the oil/water interfaces in the mixed-wet samples are saddle-shaped with two opposite, but almost equal, curvatures in orthogonal directions. The mean curvature, which determines the capillary pressure, is low, but the shape of the interfaces ensures, topologically, well-connected phases, which helps to explain the favourable oil recovery obtained in these cases. We suggest that the combination of imaging and flow experiments – which we call iSCAL – represents a compelling development in special core analysis. This methodology provides the data traditionally acquired in SCAL studies, but with insight into displacement processes, rigorous quality control, and flexibility over sample selection, while generating detailed datasets for the calibration and validation of numerical pore-scale flow models.

Experimental Study of Strong Imbibition in Microcapillaries Representing Pore/throat Characteristics of Tight Rocks

Microfluidic Study on the Effect of Single Pore-Throat Geometry on Spontaneous Imbibition

Wetting Dynamics of Spontaneous Imbibition in Porous Media: from Pore Scale to Darcy Scale

Towards improved understanding of spontaneous imbibition into dry porous media using pore-scale direct numerical simulations

The Spontaneous Imbibition of Micro/Nano Structures in Tight Matrix and the Influence on Imbibition Potential

A new interacting capillary bundle model on the multiphase flow in micropores of tight rocks

Prediction of spontaneous imbibition with gravity in porous media micromodels

Spontaneous imbibition in tight porous media with different wettability: Pore-scale simulation

A dynamic pore-network model for spontaneous imbibition in porous media

The effect of microstructure and rock mineralogy on water imbibition characteristics in tight reservoirs

Spontaneous Imbibition of Capillaries under the End Effect and Wetting Hysteresis

Pore-Scale Dynamics of Liquid CO2–Water Displacement in 2D Axisymmetric Porous Micromodels Under Strong Drainage and Weak Imbibition Conditions: High-Speed μPIV Measurements

Spontaneous imbibition in porous media: from pore scale to Darcy scale

Theoretical Investigation of Nonlinear-Diffusion Countercurrent Imbibition for Porous Medium with Micro-/Nanopores

Validation of Model Predictions of Pore-Scale Fluid Distributions During Two-Phase Flow

Capillary imbibition and flow of wetting liquid in irregular capillaries: A 100-year review

Pore‐scale Modeling of Spontaneous Imbibition in Porous Media Using the Lattice Boltzmann Method

iSCAL for Complete Rock Characterization: Using Pore-Scale Imaging to Determine Relative Permeability and Capillary Pressure

Imbibition characteristics and mechanisms of coal using digital image subtraction technique based on Micro-CT

Effect of Water Distribution on Spontaneous Imbibition of Tight Rocks: A Fractal Approach