Abstract:Nonlinear buckling of elastic thin films on compliant substrates is studied by modeling and simulations to reveal the roles of pre-strain, elastic modulus ratio, and interfacial properties in morphological transition from wrinkles to buckle-delamination blisters. The model integrates an interfacial cohesive zone model with the Föppl–von Kármán plate theory and Green function method within the general framework of energy minimization. A kinetics approach is developed for numerical simulations. Subject to a uniaxial pre-strain, the numerical simulations confirm the analytically predicted critical conditions for onset of wrinkling and wrinkle-induced delamination, with which a phase diagram is constructed. It is found that, with increasing pre-strain, the equilibrium configuration evolves from flat to wrinkles, to concomitant wrinkles and buckle-delamination, and to an array of parallel straight blisters. The height and width of the buckle-delamination blisters can be approximately described by a set of scaling laws with respect to the pre-strain and interfacial toughness. Subject to an equi-biaxial pre-strain, the critical conditions are determined numerically to construct a similar phase diagram for the buckling modes. Moreover, by varying the pre-strain, modulus ratio, and interfacial toughness, a rich variety of equilibrium configurations are simulated, including straight blisters, and network blisters with or without wrinkles. These results provide considerable insight into diverse surface patterns in layered material systems as a result of the mechanical interactions between the film and the substrate through their interface, which suggests potential control parameters for designing specific surface patterns.

Dynamic Compression of Soft Layered Materials Yields Tunable and Spatiotemporally Evolving Surface Patterns

Spatially Configuring Wrinkle Pattern and Multiscale Surface Evolution with Structural Confinement

Hierarchical Structures: Spatially Configuring Wrinkle Pattern and Multiscale Surface Evolution with Structural Confinement (adv. Funct. Mater. 1/2018)

Surface Effects on the Mechanical Behavior of Buckled Thin Film

Wrinkles Riding Waves in Soft Layered Materials

Surface effects on the wrinkles in a stiff thin film bonded to a compliant substrate

Wrinkles: Wrinkles Riding Waves in Soft Layered Materials (Adv. Mater. Interfaces 1/2019)

Controlling Elastic Wave Propagation in A Soft Bilayer System Via Wrinkling-Induced Stress Patterns

Wrinkling of a Stiff Film Resting on a Fiber-Filled Soft Substrate and Its Potential Application As Tunable Metamaterials

Quantitative predictions of diverse wrinkling patterns in film/substrate systems

Dynamics of wrinkling in ultrathin elastic sheets

Finite Deformation Mechanics In Buckled Thin Films On Compliant Supports

Wrinkle, fold, and ridge patterns of thin films attached to a compliant substrate: Direct numerical simulations involving plastic yielding

Instabilities of Soft Films on Compliant Substrates

Effects of Tension–compression Asymmetry on the Surface Wrinkling of Film–substrate Systems

Tunable Spatially Dependent Wrinkling Morphologies on Pre-Curved Surfaces

Dynamic Wrinkling Instability of Elastic Films on Viscoelastic Substrates

Nonlinear Analysis of Compressed Elastic Thin Films on Elastic Substrates: from Wrinkling to Buckle-Delamination

Effects of Viscosity and Loading Rate on Wrinkling Dynamics and Coarsening of Floating Sheets

Mechanics of micropattern-guided formation of elastic surface instabilities on the polydimethylsiloxane bilayer

Unconventional Localization Prior to Wrinkles and Controllable Surface Patterns of Film/substrate Bilayers Through Patterned Cavities