Solubility Measurement and Thermodynamic Model Correlation and Evaluation of Macitentan Form I in Five Pure Solvents (Methanol, Ethanol, n -Propanol, Isopropanol, and N , N -Dimethylformamide) and Their Solvent Mixtures

Weiwei Li,Guotong Tong,Luping Lv,Guoquan Zhou

DOI: https://doi.org/10.1021/acs.jced.1c00613

IF: 3.119

2022-05-18

Journal of Chemical & Engineering Data

Abstract:In this work, the solubility of macitentan form I in four mixtures (N,N-dimethylformamide, DMF + methanol, ethanol, n-propanol, and isopropanol) at T = 273.15–313.15 K and at atmospheric pressure was studied. At all studied temperatures, the solubility increased monotonically with the increase in the mass fraction of DMF; the largest mole solubility was 1.393 × 10–1 at 313.15 K in pure DMF. The minimum value was observed in pure alcohols. In mixtures of DMF + methanol, the values varied from 6.094 × 10–4 to 1.393 × 10–1 at 313.15 K, an increase of 228.6-fold and 278.8-fold, 319.3-fold, and 529.1-fold for mixtures of DMF + ethanol, DMF + n-propanol, and DMF + isopropanol, respectively. The values of the relative average deviation (RAD) in binary mixtures of DMF + methanol, DMF + ethanol, DMF + n-propanol, and DMF + isopropanol for the Jouyban–Acree model were 0.33, 0.23, 0.60, and 0.29%, respectively. However, for the CNIBS/R-K model, the maximum data of RAD was 3.73% at 273.15 K in the mixture of DMF + methanol. The data of the residual sum of squares (RSS) for the Jouyban–Acree model and the CNIBS/R-K model were 9.20 × 10–7 and 1.77 × 10–5, respectively. The Jouyban–Acree model provided the best correlation results due to the lowest RAD and RSS. The result of the analysis suggests that the Jouyban–Acree model is the most suitable to describe the dissolution behavior of macitentan in four binary mixtures.

engineering, chemical,thermodynamics,chemistry, multidisciplinary