Abstract:A redistribution of stress is caused by the excavation of a new tunnel within the soil surrounding the existing shield tunnel structure. This stress redistribution results in alterations to the soil and water loads around the existing tunnel structure, ultimately impacting its stress and deformation. The deformation response of existing tunnels is primarily focused on in most existing studies, with limited research conducted on the coupling system of new tunnel excavation, soil stress state, and deformation and stress of existing tunnels. This paper proposed an innovative methodology to predict deformation in existing tunnel structures and estimate additional stress during the excavation of a new shield tunnel. The reliability of the suggested calculation method was verified using measured internal force and convergence data of the structures. The results demonstrated that the Long Short-Term Memory (LSTM) model could more effectively establish the temporal correlation between the excavation parameters of new tunnels and the deformation of existing tunnels. Compared to the Recurrent Neural Network (RNN) model, the R2 of the LSTM model increased by 11.81% in the prediction of the tunnel waist and 9.38% in the prediction of the tunnel crown. The Light gradient boosting machine (LightGBM) algorithm was used to analyze the crucial factors of deformation of the existing tunnel structures during shield tunneling, and the results showed that the relative position and the average earth pressure were the essential factors. Furthermore, a calculation method for the additional stress of existing tunnel structures was proposed based on the load structure model. The method assumed that the additional load was distributed rectangularly at the top and bottom of the existing tunnel, and triangularly at the waist of the tunnel. The comparison between the calculated results and the measured results indicated that the phased characteristics of the internal force changes in the existing tunnel structure during the construction of a new tunnel could be accurately reflected by this method.

Analysis and Prediction of Nonuniform Deformation in Composite Strata During Tunnel Excavation

Numerical Modeling of Soil and Structure Behavior for Tunneling in Different Types of Soil

Ground Displacements Due to the Deformations of Shallow Tunnels with Arbitrary Cross Sections in Soft Ground

Physical Model Test and Application of 3D Printing Rock-Like Specimens to Laminated Rock Tunnels

Measurement on Soil Deformation and Numerical Simulation During Tunneling Process

Analysis of the factors influencing the nonuniform deformation and a deformation prediction model of soft rock tunnels by data mining

Influence of adjacent shield tunneling construction on existing tunnel settlement: field monitoring and intelligent prediction

Analysis of Influence of Deformation Modes of Retaining Structures on Deformation of a Side Shield Tunnel

LSTM-based Deformation Forecasting for Additional Stress Estimation of Existing Tunnel Structure Induced by Adjacent Shield Tunneling

Prediction Methods on Tunnel-Excavation Induced Surface Settlement Around Adjacent Building

Analysis and Warning Prediction of Tunnel Deformation Based on Multifractal Theory

Prediction of Surface Settlement Induced by Shallow Excavation Tunneling

Spatial deformation prediction method of fractured rock tunnel based on quantified GSI and its application

Deformation characteristics of deep excavations based on mass data

Deformation Prediction Model of Existing Tunnel Structures with Equivalent Layered Method–Peck Coupled under Multiple Factors

Analytical Method for Predicting Tunnel Heave Due to Overlying Excavation Considering Spatial Effect

Multi-objective Optimization-Based Prediction of Excavation-Induced Tunnel Displacement

The Construction and Application of a Deep Learning-Based Primary Support Deformation Prediction Model for Large Cross-Section Tunnels

Time-series prediction of settlement deformation in shallow buried tunnels based on EMD-SSA-GRNN model

Machine Learning in Conventional Tunnel Deformation in High In Situ Stress Regions

Failure mechanism and deformation prediction of soft rock tunnels based on a combined finite–discrete element numerical method