Abstract:ABSTRACT Introduction: Orthodontists have been using clear aligners to treat malocclusions, and one potential effect of treatment with orthodontic aligners is the intrusion and/or resists extrusion of the posterior teeth. This “bite-block effect” is primarily anecdotal due to the frequent occurrence of posterior open bites in patients after clear aligner therapy. Objective: The purpose of this study was to compare changes promoted by clear aligners and traditional fixed appliances in cephalometric measurements of the vertical dimension and molar position in adult patients with Class I malocclusion treated with non-extraction. Methods: Pre- and post-treatment lateral cephalometric radiographs of adult patients treated with either clear aligners (n=44) or traditional fixed appliances (n=22) were selected for retrospective analysis. Eight interval measurements and one nominal measurement were evaluated: anterior overbite (OB), mandibular plane angle related to cranial base (SN_MP) and related to Frankfort (FMA), lower molar height (L6H) and upper molar height (U6H), palatal plane to mandibular plane angle (PP_MP), lower facial height (LFH), total facial height (TFH), and posterior open bite (Posterior_OB). A single evaluator traced all cephalographs, and changes in select measures of the vertical dimension were compared within and between groups. Results: OB decreased (1.15 mm) and L6H increased (0.63 mm) in the traditional fixed appliance group. Mandibular plane angles (related to cranial base and to Frankfort) increased (0.43° and 0.53°, respectively) in the clear aligner group, but just FMA showed significant difference between groups (difference of 0.53°). LFH and TFH increased (ranging from 0.52 mm to 0.80 mm) in both groups, with no differences between treatment modality. Presence of visible posterior open bite significantly increased over the course of treatment. OB, FMA and L6H exhibited an interaction between treatment stage (pre- and post-treatment) and modality (clear aligner therapy and traditional fixed appliances), but no interaction among these three variables was found. Conclusions: The evidence does not support the theory that clear aligner therapy produces better vertical dimension control than traditional fixed appliances. Traditional fixed appliance therapy slightly extruded the lower molar, and clear aligner therapy produced a slightly mandibular backward rotation.

Preformed Intrusion Bulbs on Clear Aligners Facilitate Active Vertical Control in a Hyperdivergent Skeletal Class II Case with Extraction: A Case Report with 4-Year Follow-Up

Skeletal Class II Malocclusion Management with Clear Aligners and Mini-Implants

Vertical Control of a Severe Hyperdivergent Skeletal Class II Malocclusion with Steep Posterior Occlusal Plane in a Camouflage Case

Nonsurgical synergistic full-arch vertical intrusion treatment of bimaxillary protruded hyperdivergent skeletal Class II malocclusion using aligners

Treatment of severe Class II skeletal malocclusion in a hyperdivergent adult patient via hybrid clear aligner approach: A case report

Active vertical control with skeletal anchorage for optimizing facial profile in a severe Class II high-angle protrusion case

Clear aligner treatment assisted by mini screw for an adult with Class II division 2 malocclusion and a right upper canine completely outside of the dental arch: A case report

A Quantitative Analysis of Facial Changes after Orthodontic Treatment with Vertical Control in Patients with Idiopathic Condylar Resorption.

Transparent aligners: An invisible approach to correct mild skeletal class III malocclusion

Innovations in Orthodontics: Skeletal Versus Dentoalveolar Expansion Utilizing Clear Aligners and TAD-Assisted Expanders

Analysis of the Changes in Occlusal Plane Inclination in a Class II Deep Bite “Teen” Patient Treated with Clear Aligners: A Case Report

Nonsurgical treatment of a hyperdivergent skeletal Class III patient with mini-screw-assisted mandibular dentition distalization and flattening of the occlusal plane.

Vertical control for improved camouflage orthodontic treatment outcome in a patient with skeletal Class II malocclusion and temporomandibular joint osteoarthrosis

Transforming Adolescent Smiles: Correcting Skeletal Mandibular Retrusion and Bimaxillary Protrusion with Clear Aligners

Protraction of a Mandibular Second Molar into the Adjacent Atrophic First-Molar Extraction Site with Ridge-Split Technique Through Clear Aligners: A Case Report.

Cephalometric evaluation of changes in vertical dimension and molar position in adult non-extraction treatment with clear aligners and traditional fixed appliances

Treatment of Vertical Maxillary Excess and Skeletal Class II Malocclusion: A Case Report

TADS assisted camouflage orthodontic treatment of class ii malocclusion in a non-growing patient- A case report

Intercepting of Class III Malocclusion with a Novel Mechanism Built on the Orthopaedic Appliance: A Case Report

Uprighting and protraction of two unilateral mandibular molars using a cantilever arm through a sophisticated biomechanical system with clear aligner: A case report

Simplifying the approach of open bite treatment with aligners and selective micro-osteoperforations: An adult case report