Vapor Condensation Heat Transfer on Two-Tier Hierarchical Microstructured Surface

Xiangwei Yin,Gangtao Liang
DOI: https://doi.org/10.1016/j.ijmultiphaseflow.2023.104430
IF: 4.044
2023-01-01
International Journal of Multiphase Flow
Abstract:Condensation heat transfer on the hierarchical microstructured surfaces is simulated using a three-dimensional phase-change lattice Boltzmann method. Parametric effects raised by widely varying primary micropillar spacing, secondary micropillar position and height, surface wettability and subcooling on the condensation heat transfer are discussed in detail. The condensation heat flux first increases but then decreases with the increase spacing between primary micropillars. Droplets are prone to nucleate on the top sides of primary micropillars with smaller pillar spacing, and they tend to maintain the Cassie-Baxter state when secondary micropillars are arranged on the lateral sides of primary micropillars. As the height of secondary micropillar increases, the heat flux first increases but then decreases thereafter. When the contact angle rises from 57 degrees to 130 degrees, the state condensate droplet changes from the Wenzel state to the partial wetting state. It is also found that there exist four types of droplet nucleation sites on the hierarchical microstructured surface: at the bottom of secondary micropillars, at the corner between primary micropillars and substrate, between two adjacent primary micro pillars, and at the center of substrate between four primary micropillars. The increase of subcooling is favorable for nucleation, and the heat flux and condensation rate increase in accordance.
What problem does this paper attempt to address?